Owner`s manual

Maintenance
86
gine accidentally starts when you are
near the propeller. Before inspecting, re-
moving, or installing the propeller, move
the control lever to the neutral position,
turn the main switch to the “ ” (off) po-
sition, remove the key, and remove the
clip from the engine shut-off switch. Turn
off the battery cut-off switch if your boat
has one.
Do not use your hand to hold the propeller
when loosening or tightening the propeller
nut. Place a block of wood between the anti-
cavitation plate and the propeller to prevent
the propeller from turning.
Checkpoints
 Check each of the propeller blades for ero-
sion from cavitation or ventilation, and oth-
er damage.
 Check the propeller shaft for damage.
 Check the splines for wear and damage.
 Check for fish line tangled around the pro-
peller shaft.
EMU41991
Removing propeller
1. Straighten the cotter pin and pull it out
using a pair of pliers.
2. Remove the propeller nut, washer, and
spacer. WARNING! Do not use your
hand to hold the propeller when loos-
ening the propeller nut.
[EWM01890]
3. Remove the propeller and thrust wash-
er.
ZMU06953
1. Propeller shaft
1. Cotter pin
2. Propeller nut
3. Washer
4. Spacer
5. Propeller
6. Thrust washer
1
ZMU06954
4
3
2
1
5
6
ZMU07269
6CE-9-34-1E0.book 86 ページ ２０１２年１１月２３日 金曜日 午後１時１３分