User Manual

Input channels

V5 Reference Manual

MIX buses can be either a FIXED type that features a fixed send level, or a VARI type that

features a variable send level. The MATRIX buses are all VARI type. You can switch between

FIXED and VARI types for each two adjacent odd/even-numbered MIX buses. To do so, press

the SETUP button and then the BUS SETUP button to open the BUS SETUP window.

 If the MIX bus is a FIXED type

A gray circle is displayed instead of the TO MIX SEND LEVEL knob, and you cannot

adjust the send level.

 For a VARI type MIX bus or a MATRIX bus

Use the [TOUCH AND TURN] knob to adjust the send level.

 If the MIX/MATRIX bus is a stereo bus

You can link the main parameters of two adjacent odd/even-numbered MIX/MATRIX

buses. If the send-destination MIX/MATRIX bus is assigned as stereo, the left knob of the

two adjacent TO MIX/MATRIX SEND LEVEL knobs will operate as the TO MIX/MATRIX

PAN knob. (If BALANCE mode is selected in the TO STEREO/MONO window, it will

operate as a BALANCE knob).

NOTE

• For an INPUT channel (monaural), the right knob will adjust the common send level to the two

MIX/MATRIX buses, and the left knob will adjust the panning between the two MIX/MATRIX

buses. Rotating the left TO MIX/MATRIX SEND PAN knob counter-clockwise will increase the

amount of signal sent to the odd-numbered MIX/MATRIX bus, and rotating it clockwise will

increase the amount sent to the even-numbered MIX/MATRIX bus.

• For a ST IN channel (stereo), if BALANCE mode has been selected in the TO STEREO/MONO

window (8ch), the right knob adjusts the common send level for the two MIX/MATRIX buses, and

the left knob adjusts the volume balance of the left and right signals sent to the two MIX/MATRIX

buses. Rotating the left TO MIX/MATRIX SEND BAL knob counter-clockwise will increase the

amount of signal sent from the L-channel to the odd-numbered MIX/MATRIX bus, and rotating it

clockwise will increase the amount sent from the R-channel to the even-numbered MIX/MATRIX

bus. If PAN mode has been selected in the TO STEREO/MONO window (8ch), the left knob will

function as the PAN knob. The right knob will function as send level, just as in BALANCE mode.

MIX SEND/MATRIX SEND window

1 ALL PRE button

Sets the send point to PRE. (The send point is the point at which signals are sent from

all send-source channels — including the input and output channels — to the selected

send destination.) At this time, the PRE/POST button will light.

13 32 1 2

8 8