User Manual

Input channels

V5 Reference Manual

2 Channel select button

Lights to indicate the currently-selected input channel. Press the button to select the

channel.

3 Delay setting knob (input channels only)

Use the [TOUCH AND TURN] knob to set the value. You can view the current value

immediately beside the knob (always shown in unit of ms) and below the knob (shown

using the currently-selected scale).

NOTE

If ms (millisecond) has been selected for the DELAY SCALE, nothing will appear to the right of

the knob.

Additional functions for stereo input channels

With V3, you can temporarily set the signals sent to a stereo input channel as mono. You can

select from the following three settings.

 L-MONO

Only the L channel is temporarily set as a mono signal.

 R-MONO

Only the R channel is temporarily set as a mono signal.

 LR-MONO

Although the result is a monaural signal that is the summation of signals from both channels,

the R channel of the stereo input channel is muted.

NOTE

• When you set LR-MONO, the PAN mode is selected at the same time. In addition, the PAN knob

is set to the center position.

• When you set LR, L-MONO, or R-MONO, the BALANCE mode is selected at the same time. In

addition, the BALANCE knob is set to the center position.

 Setting procedure

If a stereo input channel is selected, the SELECTED CHANNEL VIEW screen will appear as

shown below.

STEREO IN Lch

STEREO IN Rch

STEREO R

STEREO L

PAN/BAL

STEREO IN Lch

STEREO IN Rch

STEREO R

STEREO L

PAN/BAL