User Manual

OUTPUT channels

Reference Manual

6 DELAY button

Switches the output port delay on or off.

7 Ø (Phase) button

Switches the phase of the signal assigned to the output port between normal phase

(black) and reverse phase (yellow).

8 GAIN knob

Adjusts the output gain of the output port. To adjust this value, press the knob on screen

to select it, and then operate the [TOUCH AND TURN] knob. Rotate the knob to set the

value in 1.0 dB steps. Rotate the knob while pressing and holding it down to set the

value in 0.1 dB steps. The current value appears immediately below the knob.

9 Level meter

Indicates the level of the signal assigned to the output port.

0 Tabs

Switch the output ports controlled in groups of up to eight ports. Tabs are categorized

into three groups: DANTE, SLOT, and PATCH VIEW. To display tabs in the desired group,

press the group name button located at the right or left end of the bottom row.

Using the PORT TO PORT function

Use the PORT TO PORT function to output from an input jack on the rear panel to a Dante

connector without sending the signal through the mixer. This allows you to use the I/O jacks

on QL series consoles as I/O jacks for an audio network.

STEP

1. In the Function Access Area, press the SETUP button.

Press the OUTPUT PORT button in the SYSTEM SETUP field located in the center of the

SETUP screen.

3. Press the channel select button in the OUTPUT PORT screen.

4. In the CH SELECT screen, select the output port.

ADHA

Dante

SLOT

Dante

SLOT

INPUT

OUTPUT

OUTPUT PATCH

INPUT PATCH