User Manual

QL Editor Owner’s Manual

❏ TO STEREO/MONO

Here you can specify how the signal will be sent from the input channel to the STEREO bus/MONO bus.

MODE

• ST/MONO button

When this button is on, the signal will be sent to the STEREO L/R bus and independently to the MONO bus.

• LCR button

When this button is on, the signal will be sent to the L/C/R buses which work in conjunction with each other.

PAN

(PAN/BALANCE for ST IN)

The PAN knob adjusts the panning of the signal sent from the input channel to the STE-

REO bus L/R channels. You can set this to the center position by holding down the

<Ctrl>(< >) key of the computer keyboard and clicking the knob. You can select Pan or

Balance for ST IN. The BALANCE knob adjusts the balance of the signal that is sent from

the ST IN channel to the STEREO bus L/R channels. PAN/BALANCE can be switched

with the [PAN]/[BALANCE] buttons.

ST Switches the signal sent from the input channel to the STEREO bus on/off.

M(C) Switches the signal sent from the input channel to the MONO bus on/off.

PAN

(PAN/BALANCE for ST IN)

The PAN knob adjusts the panning of the signal that is sent from the input channel to each

of the L/C/R channels. You can set this to the center position by holding down the

<Ctrl>(< >) key of the computer keyboard and clicking the knob. You can select Pan or

Balance for ST IN. The BALANCE knob adjusts the balance of the signal that is sent from

the ST IN channel to the STEREO bus L/R channels. PAN/BALANCE can be switched

with the [PAN]/[BALANCE] buttons.

CSR (Center Side Ratio)

Adjusts the proportion of the CENTER channel level relative to the STEREO bus L/R in a

range of 0–100%.

[INPUT CH 1–64] [ST IN channel 1–8]