User Manual

Yamaha Professional Audio QL StageMix V7 User Guide
Page 31
state and can be pressed to change the state. The [PRE] button
appears yellow when On and grey when Off.
4.11.4 Global PRE/POST
Press and hold a [PRE] button to make global Pre or Post fader
assignments. A popup will appear providing the following options:
• ALL MIX/MATRIX BUSSES PRE FOR THIS CHANNEL
• ALL MIX/MATRIX BUSSES POST FOR THIS CHANNEL
• CURRENT MIX/MATRIX BUS PRE FOR ALL CHANNELS
• CURRENT MIX/MATRIX BUS POST FOR ALL CHANNELS
4.11.5 Stereo Mix Pan
When a Stereo Mix Bus is active as the “Target Mix Bus”, a Pan slider
will be available at the top of each channel strip in “SENDS ON
FADERS” mode. Adjusting this slider will change the Pan position for
that channel’s send to the currently active Stereo Mix Bus. The Pan
position’s numerical value appears above the slider.
If the Pan Link function is active for the currently active Stereo Mix Bus,
a link icon will appear below the Pan slider. When Pan Link is active,
adjusting a channel’s Pan slider will affect the Pan parameter for that
channel to the Master Stereo Bus and all other linked Stereo Mix
Busses.
Note: Pan Link mode for each Stereo Mix Bus can only be activated in
the console, not from StageMix.
To exit “SENDS ON FADERS” mode, press the [SENDS ON FADERS] button
in the left column.
4.11.6 Selected MIX/MTX Overview in Sends on Faders
When Sends On Faders mode is first entered, an overview of the
parameters of the selected Mix or MT channel is displayed by default in
the area above the faders.
On the left side is displayed the selected Mix or MT number and name
with colour, fader level indication of the Mix/MT bus with arrows for
nudge control of the mix output level, Cue and ON buttons, PAN/BAL
control and Stereo/Mono bus routing indication and control (Mix only).
The right side displays thumbnail views of the PEQ, Dynamics and
Inserted processors, and these can be used to directly access those
editors.
To access Mix/MT Send Pan control for input channels for the selected
send bus, use the arrow buttons of the control strip, above the [SETUP]
button. To return the Selected Mix/MT view again, use the same arrow
buttons.
When a Stereo Mix or Matrix is selected, a small L/R indication is
displayed above the Mix/MT number and name. This shows which side
of current Stereo Mix/MT is currently displayed. Touch on this indication