MSDS

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
831648 - Fuel Med RX-04
Page 2/7
Issue date: 22-Aug-2018 Status: FINAL
SECTION 4: First aid measures
Eye Contact: If irritation or redness develops from exposure, flush eyes with clean water. If symptoms persist, seek medical
attention.
Skin Contact: Immediately flush affected area(s) with large amounts of water while removing contaminated shoes, clothing, and
constrictive jewelry. If skin surface is damaged, apply a clean dressing and seek immediate medical attention. If skin surface is not
damaged, cleanse the affected area(s) thoroughly by washing with mild soap and water or a waterless hand cleaner. If irritation or
redness develops, seek immediate medical attention. Wash contaminated clothing before reuse.
Inhalation: First aid is not normally required. If breathing difficulties develop, move victim away from source of exposure and into
fresh air in a position comfortable for breathing. Seek immediate medical attention.
Ingestion: Aspiration hazard: Do not induce vomiting or give anything by mouth because this material can enter the lungs and
cause severe lung damage. If victim is drowsy or unconscious and vomiting, place on the left side with the head down. If possible,
do not leave victim unattended and observe closely for adequacy of breathing. Seek medical attention.
Most important symptoms and effects, both acute and delayed: While significant vapor concentrations are not likely, high
concentrations can cause minor respiratory irritation, headache, drowsiness, dizziness, loss of coordination, disorientation and
fatigue. Ingestion can cause irritation of the digestive tract, nausea, diarrhea, and vomiting. Prolonged or repeated contact may dry
skin and cause irritation.
Notes to Physician: Acute aspirations of large amounts of oil-laden material may produce a serious aspiration pneumonia.
Patients who aspirate these oils should be followed for the development of long-term sequelae. Inhalation exposure to oil mists
below current workplace exposure limits is unlikely to cause pulmonary abnormalities.
SECTION 5: Firefighting measures
NFPA 704: National Fire Protection
Association
Extinguishing Media: Dry chemical, carbon dioxide, foam, or water spray is recommended. Water or foam may cause frothing of
materials heated above 212°F / 100°C. Carbon dioxide can displace oxygen. Use caution when applying carbon dioxide in
confined spaces. Simultaneous use of foam and water on the same surface is to be avoided as water destroys the foam.
Specific hazards arising from the chemical
Unusual Fire & Explosion Hazards: Combustible. This material can be ignited by heat, sparks, flames, or other sources of
ignition (e.g., static electricity, pilot lights, or mechanical/electrical equipment). May create vapor/air explosion hazard if heated.
This product will float and can be reignited on surface water. Vapors are heavier than air and can accumulate in low areas. If
container is not properly cooled, it can rupture in the heat of a fire.
Hazardous Combustion Products: Combustion may yield smoke, carbon monoxide, and other products of incomplete
combustion. Oxides of sulfur, nitrogen or phosphorus may also be formed.
SECTION 3: Composition/information on ingredients
Chemical Name CASRN Concentration
Distillates, petroleum, hydrotreated heavy naphthenic 64742-52-5 <85
Hydrocarbons, C11-C14, n-alkanes, isoalkanes, cyclics, <2% aromatics 64742-47-8 <15
Alkyl Imidazoline VARIOUS 0.25-0.49
N,N'-di-sec-butyl-p-phenylenediamine 101-96-2 0.1-0.24
¹ All concentrations are percent by weight unless ingredient is a gas. Gas concentrations are in percent by volume.
Health: 2 Flammability: 2 Instability: 0
0 = minimal hazard
1 = slight hazard
2 = moderate hazard
3 = severe hazard
4 = extreme hazard