MSDS

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
831648 - Fuel Med RX-04
Page 4/7
Issue date: 22-Aug-2018 Status: FINAL
Chemical Name
ACGIH OSHA Mexico Phillips 66
Distillates, petroleum,
hydrotreated heavy
naphthenic
TWA: 5mg/m
3
STEL: 10 mg/m
3
as Oil Mist, if Generated
--- --- ---
Hydrocarbons, C11-C14,
n-alkanes, isoalkanes,
cyclics, <2% aromatics
TWA: 200 mg/m
3
Skin
--- --- ---
Note: State, local or other agencies or advisory groups may have established more stringent limits. Consult an industrial
hygienist or similar professional, or your local agencies, for further information.
Note: None
Engineering controls: If current ventilation practices are not adequate to maintain airborne concentrations below the established
exposure limits, additional engineering controls may be required.
Eye/Face Protection: The use of eye protection that meets or exceeds ANSI Z.87.1 is recommended to protect against potential
eye contact, irritation, or injury. Depending on conditions of use, a face shield may be necessary.
Skin/Hand Protection: The use of gloves impervious to the specific material handled is advised to prevent skin contact. Users
should check with manufacturers to confirm the breakthrough performance of their products. Depending on exposure and use
conditions, additional protection may be necessary to prevent skin contact including use of items such as chemical resistant boots,
aprons, arm covers, hoods, coveralls, or encapsulated suits. Suggested protective materials: Nitrile rubber
Respiratory Protection: Where there is potential for airborne exposure above the exposure limit a NIOSH certified air purifying
respirator equipped with organic vapor cartridges/canisters with R or P95 filters may be used.
A respiratory protection program that meets or is equivalent to OSHA 29 CFR 1910.134 and ANSI Z88.2 should be followed
whenever workplace conditions warrant a respirator's use. Air purifying respirators provide limited protection and cannot be used in
atmospheres that exceed the maximum use concentration (as directed by regulation or the manufacturer's instructions), in oxygen
deficient (less than 19.5 percent oxygen) situations, or under conditions that are immediately dangerous to life and health (IDLH).
Other Protective Equipment: Eye wash and quick-drench shower facilities should be available in the work area. Thoroughly
clean shoes and wash contaminated clothing before reuse.
Suggestions provided in this section for exposure control and specific types of protective equipment are based on readily
available information. Users should consult with the specific manufacturer to confirm the performance of their protective
equipment. Specific situations may require consultation with industrial hygiene, safety, or engineering professionals.
SECTION 9: Physical and chemical properties
Note: Unless otherwise stated, values are determined at 20°C (68°F) and 760 mm Hg (1 atm). Data represent typical values and are not intended
to be specifications.
SECTION 10: Stability and reactivity
Reactivity: Not chemically reactive.
Occupational exposure limits
The following constituents are the only constituents of the product which have a PEL, TLV or other recommended exposure limit.
At this time, the other constituents have no known exposure limits.
Biological occupational exposure limits
Appearance: Red Flash Point: 178 °F / 81 °C
Physical Form: Liquid Test Method: Pensky-Martens Closed Cup (PMCC), ASTM D93, EPA 1010
Odor: Slight hydrocarbon Initial Boiling Point/Range: No data
Odor Threshold: No data Vapor Pressure: <1 mm Hg
pH: Not applicable Partition Coefficient (n-octanol/water) (Kow): No data
Vapor Density (air=1): >1 Melting/Freezing Point: No data
Upper Explosive Limits (vol % in air): No data Auto-ignition Temperature: No data
Lower Explosive Limits (vol % in air): No data Decomposition Temperature: No data
Evaporation Rate (nBuAc=1): No data Specific Gravity (water=1): 0.8745 @ 60ºF (15.6ºC)
Particle Size: Not applicable Bulk Density: 7.28 lbs/gal
Percent Volatile: No data Viscosity: 3.6 cSt @ 100°C; 18.6 cSt @ 40°C
Flammability (solid, gas): Not applicable Pour Point: No data
Solubility in Water: Negligible