Safety Brochure

6
NOTICE
Indicates points that you must observe in order
to prevent product failure, damage or
malfunction and data loss.
Power supply
• If not using the unit for a long period of time, be sure to
pull the power plug from the outlet. Even if the power
switch has been turned off (the power light is off), a
minute current is still flowing.
• Do not turn the unit on again within 10 seconds after
turning it off. Otherwise, noise may occur.
Installation
• Do not use this unit in the vicinity of other electronic
equipment, such as a TV, radio, or mobile phone.
Failure to observe this may cause this unit or the TV or
radio to produce noise.
• Do not use this unit in a location that is exposed to
direct sunlight that becomes extremely hot, such as
near a heater, or extremely cold, or that is subject to
excessive dust or vibration. Failure to observe this may
cause the unit's panel to become deformed, the
internal components to malfunction, or for operation to
become unstable.
Connections
• If connecting external units, be sure to thoroughly read
the manual for each unit and connect them in
accordance with the instructions. Failure to properly
handle a unit in accordance with the instructions could
cause malfunctions.
• Do not use both balanced and unbalanced
connections at the same time between the same two
units. Ground looping will cause noise.
Handling
• Do not place vinyl, plastic, or rubber products on this
unit. Failure to observe this may cause discoloration or
deformation in the panel of this unit.
• If the ambient temperature changes drastically (such as
during unit transportation or under rapid heating or
cooling) and there is a chance condensation may have
formed in the unit, leave the unit for several hours
without turning on the power until it is completely dry
before use. Using the unit while there is condensation
can cause malfunctions.
Maintenance
• When cleaning the unit, use a dry, soft cloth. Using
chemicals such as benzine or thinner, cleaning agents,
or chemical scrubbing cloths can cause discoloration
or deformation.
Information
About content in this manual
• The illustrations in this manual are for instructional
purposes only.