User's Manual

Page 34/62 GEO M6 HARDWARE SETUP PROCEDURE
4 to 12 (maximum) GEO M6 flown 8.3.7
Required items
- 1 or 2 hoists (not provided).
- 1 x GMT-BUMPER
- 1 x GMT-EXBAR for extended positive and negative bumper angles
- 4 VXT-BL515 per GEO M6
- 1 x GMT-6CASE for 6 x GEO M6
IMPORTANT
Maximum GEO M6 quantity for flown vertical cluster is 12 (and eventually less).
Please check NS1 for mechanical Safety Working Load and acoustic computations.
IMPORTANT
Motor hoist must be rated to support entire cluster weight. Please check configuration
in NS1 for proper motor hoist rating
Procedure with flight case set vertically
- Tip the flight case vertically
- Remove upper cover to access to top cabinet rigging points
- Connect GMT-BUMPER to top cabinet 4 x VXT-BL515 quick release pins
- If required, connect GMT-EXBAR to GMT-BUMPER by inserting EXBAR clevis pins into GMT-
BUMPER “B” and “D” holes
- Connect single hoist to required hole as indicated in NS1 design
o “A”, “B”, “C”, “D” or “E” on GMT-BUMPER
o Or “1” to “9” if using GMT-EXBAR
o If using 2 hoists, connect these using extreme points
(“A” and “E”, or “A” and “9” or “”9” and “E”)
GMT-BUMPER and GMT-EXBAR referenced rigging points
IMPORTANT
Ensure hoist hook(s) is (are) properly secured to GMT-BUMPER