User Manual

23
- Conversion from CL/QL to M7CL:
The parameter settings of the LOW band
on CL/QL are copied to the shared
parameter settings on M7CL.
7) Only the GEQs that are mounted to Effect Rack 1-8 are converted. The GEQs mounted to CL/QL
GEQ Rack 1-16 are not converted.
8) Reproducibility of Recall Safe & Focus Recall:
Refer to section 3.8 “Recall Filter” Treatment.
9) Pan/Balance parameter is reproduced when M7CL’s configuration and CL/QL’s configuration
match. There are a few mismatched parameters due to the different concept of Pan and Balance.
For such cases, the converter will substitute a value which keeps the rule “Odd channel signal
goes to L and even channel signal goes to R”.
Input to Stereo & Input to Mix: Pan/Balance -ST IN/Fx RTN
M7CL
Pan mode
Balance mode
Pan for odd Ch
Pan for even Ch
Balance for odd & even Ch
CL/QL
Balance: Center
Balance: Copy
Balance mode (only available mode)
CL/QL
Set Balance mode
Balance: Copy
M7CL
Balance for odd & even Ch
Balance mode
LOW
RATIO
MID
RATIO
HI.
RATIO
ATTACK
RELEASE
KNEE
BYPASS
RATIO
ATTACK
RELEASE
KNEE
BYPASS
Copy
M7CL
CL/QL