User Manual

M7CL Owner’s Manual
Sending the signal from an input channel to the MATRIX buses
68
4
Use multifunction encoders 1–8 to adjust
the send level of the signals sent from the
up to eight input channels to the selected
MATRIX bus.
If necessary, you can use the navigation keys to switch
the input channels that are assigned to the Centralogic
section, and adjust the send levels from other input
channels to the selected MATRIX bus.
5
If you want to make detailed settings for
MATRIX sends, press the TO MATRIX SEND
LEVEL knob inside the bold frame once
again.
When you press the currently selected TO MATRIX
SEND LEVEL knob once again, the MATRIX SEND
popup window will appear. The window includes the
following items.
1 SEND TO
This indicates the number, channel name, and icon of
the MATRIX bus that is currently selected as the send-
destination for signals.
B ←/→ buttons
Use these buttons to switch between send-destination
buses. You can switch consecutively through MIX
buses 1–16 and MATRIX buses 1–8.
C Channel select button
This indicates the channel number, the icon selected
for that channel, and the channel name. When you
press this button, that channel will be selected for
operations, and the corresponding [SEL] key will
light.
D PRE button
This button selects the location from which the signal
of the input channel will be sent to the MATRIX bus.
The signal will be sent from POST (Immediately after
the [ON] key) if this button is off. The signal will be
sent from the PRE EQ (Immediately before the attenu-
ator) or PRE FADER (Immediately before the fader)
as specified in the BUS SETUP popup window if this
button is on.
E TO MATRIX SEND ON/OFF button
These are on/off switches for the signal sent from the
input channels to the MATRIX bus.
F TO MATRIX SEND LEVEL knob
This screen shows the send level of the signal sent
from the input channels to the MATRIX bus. To adjust
the level, operate multifunction encoders 1–8.
If the send-destination MATRIX bus is set to stereo,
the TO MATRIX PAN knob (for a ST IN channel, the
TO MATRIX BALANCE knob) and TO MATRIX
SEND LEVEL knob are shown in this location.
G ALL PRE button
This button selects PRE as the position from which
signals are sent from all input channels to VARI-type
MIX buses.
H ALL POST button
This button selects POST as the position from which
signals are sent from all input channels to VARI-type
MIX buses.
6
Use the TO MATRIX SEND ON/OFF buttons
to switch the signals sent from the input
channels to the currently selected MATRIX
bus on/off.
7
If necessary, use the PRE buttons to select
the location of the signal that is sent from
each input channel to a VARI type MATRIX
bus.
8
Repeat steps 3–6 to adjust the send level
for other MATRIX buses in the same way.
• If you want to monitor the signal being sent to a specific
MATRIX bus, use the navigation keys to access the corre-
sponding MATRIX channel in the Centralogic section, and
press the [CUE] key for that MATRIX channel.
HINT
1 7 8
2
3
4
5
6