User Manual

Network-MIDI Driver Installation Guide 8

Automatic Device Detection and Load/Save File

The “Advanced Settings” window can be opened by clicking the [Advanced Settings] button in the “Yamaha

Network-MIDI Driver” window.

“Advanced Settings” Window

The parameters in the “Advanced Settings” window set up the Network-MIDI Driver for automatic device

detection, and allow saving and loading setup files.

Auto Detect

Allows automatic detection of connected devices. A maximum of 254 addresses (***.***.***.1 through

***.***.***.254) can be detected.

n Only devices on the same subnet as the computer can be detected automatically.

Before searching for device(s) make sure that the computer is connected to the subnet to be searched, and that an

appropriate IP address is assigned.

1 Detect from

Specifies the start IP address for automatic detection.

2 Detect to

Specifies the end IP address for automatic detection.

3 Currently searching

Displays the IP address being checked during automatic detection. No display when automatic detection is not

in progress.

4 [Start] Button

Initiates automatic detection, and causes the detected device list (6) to be updated accordingly. This button is

grayed out and is not accessible during automatic detection.

5 [Abort] Button

Aborts automatic detection.

This button is grayed out when automatic detection is not in progress.

)