User Manual

M7CL V3 Editor Owner’s Manual

C HPF (High Pass Filter)

Use the [ON] button at the right to switch the high-pass ﬁlter on/off. You can use the knob at left to adjust the

cutoff frequency. The current value is shown in the numerical box below the knob. An indication of “H” will

appear on the EQ graph of the equalizer.

❏ TO STEREO/MONO

Here you can specify how the signal will be sent from the input channel to the STEREO bus / MONO bus.

MODE

• ST/MONO button

When this button is on, the signal will be sent to the STEREO L/R bus and independently to the MONO bus.

• LCR button

When this button is on, the signal will be sent to the L/C/R buses which work in conjunction with each other.

PAN (BALANCE for ST IN)

Adjusts the panning of the signal sent from the input channel to the STEREO bus L/R chan-

nels. You can set this to the center position by holding down the <Ctrl>(< >) key of the

computer keyboard and clicking the knob. This is linked with the [PAN] encoder in the

SELECTED CHANNEL section of the M7CL panel.

ST Switches the signal sent from the input channel to the STEREO bus on/off.

M(C) Switches the signal sent from the input channel to the MONO bus on/off.

PAN (BALANCE for ST IN)

Adjusts the panning of the signal that is sent from the input channel to each of the L/C/R

channels. You can set this to the center position by holding down the <Ctrl>(< >) key of

the computer keyboard and clicking the knob. This is linked with the [PAN] encoder in the

SELECTED CHANNEL section of the M7CL panel.

CSR (Center Side Ratio)

Adjusts the proportion of the CENTER channel level relative to the STEREO bus L/R in a

range of 0–100%.

[INPUT CH 1–48] [ST IN channel 1–4]