User Manual

M7CL V3 Editor Owner’s Manual

C ON(FROM MIX, ST/MONO send on/off)

These are on/off switches for the signal sent from the MIX buses or STEREO/MONO buses to the MATRIX bus.

• If MIX buses and MATRIX buses are being used in stereo, the

odd-numbered knob will be PAN.

• If the FIXED type is selected for the MIX bus, only the ON but-

ton is valid.

• The stereo/mono setting and the VARI type / FIXED type setting can be made in the Mixer Setup dialogbox.

D Channel name

This section indicates the name of the MIX channel or STEREO/MONO channel.

❏ BALANCE

This is shown only if the selected MATRIX bus is being used as stereo. It adjusts the left/right volume balance of

the stereo signal. You can set this to the center value by holding down the <Ctrl>(< >) key of your computer

keyboard and clicking this knob.

❏ EQUALIZER

This is the same as for the equalizer of a MIX channel (➥ p.42).

❏ DYNAMICS1

Except for the fact that the available types are COMPRESSOR, EXPANDER, COMPAND H and COMPAND S,

and that you can select more than one signal as the key-in signal, this is the same as the dynamics for input chan-

nels (➥ p.34).

❏ INSERT

Except for the fact that the insert points that can be selected are different, this is the same as for the insert settings

of an input channel (➥ p.38).

❏ RECALL SAFE/MUTE SAFE

These are the same as the RECALL SAFE/MUTE SAFE of a MIX channel (➥ p.43).

❏ MUTE GROUP

These are the same as the MUTE GROUP of a MIX channel (➥ p.43).

HINT

PAN (odd-numbered side)