User Manual

M7CL V3 Editor Owner’s Manual

This window shows the signal levels of each section in the M7CL, letting you check for the presence of signals and

whether an overload is occurring.

This window is divided into INPUT METER and OUTPUT METER; to switch pages, click the tabs located at the top

of the window.

In order to view the M7CL’s signal levels in the Meter window, make sure that M7CL Editor and the M7CL

itself are synchronized.

INPUT METER page

A METERING POINT

Select one of the following as the point where metering will occur.

PRE HPF, PRE FADER, POST ON

B PEAK HOLD

Switches peak hold on/off.

C Meters

These peak level meters show the input level of each channel. The current fader value is shown in the box below.

If clipping occurs at any one of the detection points in the channel, the ∑ segment will light.

Meter window

NOTE

1 2