User Manual

M7CL V2 Editor Owner’s Manual
32
❏ INSERT (except for ST IN channels)
A ON
Enables/disables insert-in/out.
B OUT (Insert out)
Click this to select the output port that will be assigned to insert-out, from the following choices.
C IN (Insert in)
Click this to select the input port that will be assigned to insert-in, from the following choices.
D POINT (Insert point)
Selects the position at which insert-in/out will be patched. Choose from PRE EQ, PRE FADER, or POST ON.
❏ DIRECT OUT (except for ST IN channels)
A ON
Tur ns the direct output on/off.
B DIRECT OUT GAIN
Adjusts the gain of the direct output. The current value is shown in the numerical box below the knob. You can set
this to the nominal value (0.0 dB) by holding down the <Ctrl> key and clicking the knob.
C DIRECT OUT PORT
Click this to select one of the following output ports as the one used for direct out.
D DIRECT OUT POINT
Selects the position at which direct out will be patched. Choose from PRE HPF, PRE EQ, PRE FADER, or POST
ON.
NONE No assignment
SLOT1-1, SLOT1-2...SLOT3-15, SLOT3-16 Output channels of an I/O card installed in slots 1–3
RACK1A, RACK1B...RACK8R(B) L/R outputs of Rack 1–8
NONE No assignment
SLOT1-1, SLOT1-2...SLOT3-15, SLOT3-16 Input channels of an I/O card installed in slots 1–3
RACK1A, RACK1B...RACK8R(B) L/R inputs of Rack 1–8
NONE No assignment
OMNI1–OMNI16 OMNI jacks 1–16
SLOT1-1, SLOT1-2...SLOT3-16 Output channels of an I/O card installed in slots 1–3
1
2 3 4
1
2 3 4