User Manual
Table Of Contents
- Contents
- Connections
- Setup Mode (Advanced settings)
- Setup Mode Operation Procedure
- Indication of Parameter Settings
- Operation Procedure
- Turning Off the Microphone Input High-Pass Filter
- Applying Compressor to the Microphone Input
- Applying EQ (equalizer) to the Input Signal
- Applying Echo/Reverb to the Input Signal
- Adjusting the Reverb Mix Level
- Adjusting the Ducker Sensitivity
- Regulating BGM Volume (Leveler)
- Setting the Chime Volume
- Adjusting the Line Out Volume by Using the [VOLUME] Knob
- Microphone Feedback Suppressor
- Initializing the settings via connected controll panels (DCP Setup)
- List of DIP Switch Settings
- Appendix
- Technical Specifications
Setup Mode (Advanced settings)
13
MA2120 Setup Guide
Setting the Chime Volume
You can set the volume of the chime that is emitted when the microphone input is turned on or off via by the control panel switch.
The volume can be set to “Mute”, “-12dB”, or “-6dB”. You can set different volumes for each zone.
1 Press and hold the [SETUP] encoder and input
level knob 1 simultaneously for at least one
second.
2 Press input level knob 1.
3 Press input level knob 1 (Zone A), or input level
knob 2 (Zone B) to select to which output
channel you would like to set the chime volume.
4 Turn the [SETUP] encoder to set the volume.
The parameter value changes with each click of the
encoder.
5 Press the [SETUP] encoder to apply the setting.
The status is back to the channel select (Step 3).
Adjusting the Line Out Volume by Using the [VOLUME] Knob
You can turn the linked operation function for [SPEAKERS] and [LINE OUT] on or off. This function allows the output signal level from the
[LINE OUT] jack to be simultaneously adjusted when the [VOLUME A] and [VOLUME B] knobs are operated.
NOTICE
When switching this parameter, set the volume of the device connected to the [LINE OUT] connector to minimum.
1 Press and hold the [SETUP] encoder and input
level knob 1 simultaneously for at least one
second.
2 Press input level knob 2.
3 Press input level knob 1 (Zone A), or input level
knob 2 (Zone B) to select to which output
channel you would like to adjust the line out
volume by using the [VOLUME] knob.
4 Turn the [SETUP] encoder to turn the linked
operation function for [SPEAKERS] and [LINE
OUT] on or off.
5 Press the [SETUP] encoder to apply the setting.
The status is back to the channel select (Step 3).
1, 2 3 1, 4, 5
Off:
-12dB:
-6dB: (Default setting)
0dB:
123 4, 5
Off: (Default setting)
On: