User Manual
Table Of Contents
- Contents
- Connections
- Setup Mode (Advanced settings)
- Setup Mode Operation Procedure
- Indication of Parameter Settings
- Operation Procedure
- Turning Off the Microphone Input High-Pass Filter
- Applying Compressor to the Microphone Input
- Applying EQ (equalizer) to the Input Signal
- Applying Echo/Reverb to the Input Signal
- Adjusting the Reverb Mix Level
- Adjusting the Ducker Sensitivity
- Regulating BGM Volume (Leveler)
- Setting the Chime Volume
- Adjusting the Line Out Volume by Using the [VOLUME] Knob
- Microphone Feedback Suppressor
- Initializing the settings via connected controll panels (DCP Setup)
- List of DIP Switch Settings
- Appendix
- Technical Specifications
163
MA2120 Setup Guide
Technical Specifications
Outputs (SPEAKER OUT)
Outputs (LINE OUT)
Inputs
Specification
Output Power
20msec Burst
(THD+N=1%)
AMP MODE = 3Ω 100W x 2ch
AMP MODE = 4Ω 120W x 2ch
AMP MODE = 8Ω 100W x 2ch
AMP MODE = 70V/120W 120W x 2ch
AMP MODE = 100V/120W 120W x 2ch
AMP MODE = 70V/200W 200W x 1ch
AMP MODE = 100V/200W 200W x 1ch
Termi n a l 7.62mm BARRIER STRIP 4pin
LINE OUT
Actual source impedance 600Ω
For use with nominal 10kΩ Lines
Output Level Nominal -10dBV (316mV)
Ter mi n a l MONO RCA PIN x2, unbalanced
MIC IN (INPUT 1-6)
Input Level
INPUT 1-6, Euro,
balanced
Sensitivity -56dBu (1.23mV)
Nominal -36dBu (12.3mV)
Max before clip -8dBu (0.309V)
LINE IN (INPUT 1-8)
Input Level
INPUT 1-6, Euro,
balanced
Sensitivity -24dBu (48.9mV)
Nominal -4dBu (0.489V)
Max before clip +24dBu (12.3V)
Input Level
INPUT 5-8, RCA,
unbalanced
Sensitivity -30dBV (31.6mV)
Nominal -10dBV (316mV)
Max before clip +10dBV (3.16V)
Input Level
INPUT 8, ST mini phone,
unbalanced
Sensitivity -30dBV (31.6mV)
Nominal -10dBV (316mV)
Max before clip +10dBV (3.16V)
Terminal
MIC/LINE IN INPUT 1-6 3.5mm Euro Block 6pin x3
balanced
LINE IN INPUT 5-6 MONO RCA PIN x4
unbalanced
INPUT 7-8 STEREO RCA PIN x2
unbalanced
INPUT 8
(Front Panel)
3.5mm STEREO mini phone x1
unbalanced