Owner's Manual
Table Of Contents
- INTRODUCTION
- IMPORTANT MANUAL INFORMATION
- IMPORTANT NOTICE
- TABLE OF CONTENTS
- SAFETY INFORMATION
- LOCATION OF THE WARNING AND SPECIFICATION LABELS
- DESCRIPTION
- INSTRUMENT AND CONTROL FUNCTIONS
- PRE-OPERATION CHECKS
- OPERATION
- RIDING YOUR ATV
- PERIODIC MAINTENANCE AND MINOR REPAIR
- CLEANING AND STORAGE
- SPECIFICATIONS
- CONSUMER INFORMATION
4-22
4
WARNING
EWB00400
Always adjust the shock absorber assemblies
on the left and right side to the same setting.
Uneven adjustment can cause poor handling
and loss of stability, which could lead to an ac-
cident.
EBU19180
Auxiliary DC jack
The auxiliary DC jack is located at the front right
side of the ATV. The auxiliary DC jack can be used
for suitable work lights, radios, etc. The auxiliary
DC jack should only be used when the engine is
running.
1. Set the light switch to “OFF”.
2. Start the engine. (See page 6-1.)
3. Open the auxiliary DC jack cap, and then in-
sert the accessory power plug into the jack.
1. Special wrench
Spring preload setting:
Minimum (soft):
1
Standard:
2
Maximum (hard):
5
U3B461E0.book Page 22 Tuesday, November 21, 2006 1:51 PM