Owner's Manual

TROUBLESHOOTING
19 En
ADDITIONAL
INFORMATION
English
In case of a transmission error without a status message appearing in the front panel of this unit, check the connection to your iPod (see
page 5).
The following status messages appear only if you are using MCR-040.
The following status messages appear only if you are using MCR-140.
The following LED statuses of the status indicator refer to the transmitter.
iPod™
Note
Status message Cause Remedy Page
iPod Connecting
iPod Charging
This unit is in the middle of recognizing
the connection with your iPod.
If the message continues to appear in the front panel
display and playback does not start, connect the iPod
again.
—
Unknown iPod
There is a problem with the signal path
from your iPod to this unit.
Connect the iPod again.
5
The iPod being used is not supported by
this unit.
Only iPod (5th generation), iPod classic, iPod nano,
and iPod touch are supported.
—
iPod
This unit has recognized your iPod;
however, it cannot obtain information
such as elapsed time.
iPod Unplugged
Your iPod was removed from the iPod
dock.
Station your iPod back in the iPod dock.
5
Status message Cause Remedy Page
iPod Linked
iPod
Wireless connection was successful.
iPod Unlinked
Wireless connection has disconnected. Connect the iPod to the transmitter and start
playback.
5
iPod Low Batt.
The battery of the iPod is getting flat. Set it in the charging cradle.
5
LED status Transmitter status Remedy Page
Off The transmitter is in standby mode.
An iPod is not connected or wireless
communication has not been established.
Flashes green Connection in progress. Please wait.
—
Flashes green once Adjusting the volume level or operating
with the remote control.
Lights up green Wireless communication between the
unit and transmitter is established.
Lights up green and
flashes red for 2
seconds
An unsupported iPod is connected. Only iPod (5th generation), iPod classic, iPod nano,
and iPod touch are supported.
5
Lights up green and
keeps flashing red
Connection failed. Connect again.
8
Flashes red Error occurs. Remove the iPod from the transmitter, and connect
again.
8
Flashes red once The volume of the unit is set to maximum
or minimum.
Flashes red 2 times
continuously
(regardless of green
status)
The battery of the iPod is low. Set the iPod in the charging cradle.
5