Owner`s manual

TROUBLESHOOTING
44 En
In case of a transmission error without a status message appearing on the front panel of this unit, check the connection to the USB
device (refer to page 13).
■ General
The iPod does not
charge up.
The iPod is not connected correctly. Connect the iPod and this unit by a USB cable
correctly.
11
The iPod is not supported by this unit. Only iPod classic, iPod nano (2nd, 3rd, 4th, 5th and
6th generation), iPod touch (1st, 2nd, 3rd, and 4th
generation), iPhone, iPhone 3G/3GS, iPhone 4, and
iPad are supported.
11
USB
Note
Status message Cause Remedy Page
USB ERROR
The connected USB device is not
playable on this unit.
Disconnect the USB device. Change input source
other than USB and select USB as input source
again. Then connect playable USB device again.
13
The USB device is connected at an
angle.
Problem Cause Remedy Page
The file in the USB
device does not play.
The USB device is not recognized. Connect the USB device again.
13
Connect an AC adapter if supplied with the device.
—
Incorrect USB device connections. Connect the USB device again.
13
The file format is not compatible with
this unit.
Replace the file with a correctly recorded file
playable with this unit.
3
If the solutions above do not resolve the
problem, the USB device is not playable
on this unit.
Try another USB device.
—
Disc playback
Problem Cause Remedy Page
No sound or
distorted sound.
The sampling rate of an audio or video
file is not compatible with this unit.
Check that the sampling rate and bit rate of an audio
or video file are compatible with this unit.
3
Audio may not be output depending on the audio
recording status, such as when audio other than an
audio signal or non-standard audio is recorded for
the audio content.
3
There is no sound during still mode, slow motion
playback, fast forward and fast reverse.
—
Problem Cause Remedy Page