Operation Manual

46 En
TROUBLESHOOTING
■ USB
Note
If a transmission error occurs but no status message is displayed on the front panel display of the receiver, check the connection between
the DVD player and the USB device (☞p.11).
The USB device
cannot be
recognized.
The USB device is not connected
correctly.
Connect the USB device correctly.
11
The DVD player is not
linked with the
receiver.
The system control cable is disconnected
from the system connector jacks of the
receiver and/or the DVD player.
Connect the system control cable properly to the
system connector jacks of the receiver and the DVD
player.
8
Status message Cause Remedy
See
page
NO USB
The USB device is not connected. Connect a playable USB device.
11
OVER CURRENT
The USB device is either unplayable on
this system or connected at an incorrect
angle.
Disconnect the USB device. Change the input source
to a device other than USB and back to USB. Then,
correctly connect a playable USB device to the DVD
player.
—
Problem Cause Remedy
See
page