Operation Manual

41 En
English
Troubleshooting
ADDITIONAL
INFORMATION
CD player (CDX-E410)
Problem Cause Remedy
See
page
Power turns on but
immediately shuts off.
The power cable is not connected or the
plug is not completely inserted.
Connect the power cable firmly.
17
Power immediately
shuts off during
playback.
Auto-standby function of the receiver
works when the receiver can not receive
the playing signal transmitted from the
CD player with the system control cable
for 30 minutes.
Check the connection of the system control cable
between the receiver and the CD player.
12
No sound or distorted
sound
The sampling rate of a MP3 or WMA file
may not be compatible with the CD
player.
Check the sampling rate and bit rate of an MP3 or
WMA file are compatible with the CD player.
42
No audio at digital
output
Incorrect digital cable connections. Connect the digital cables properly.
15
The disc being played back may not be
compatible with the CD player.
Check that the disc is compatible with the CD player.
42
Disc playback does
not start.
You may use a CD-R/RW that is not
finalized.
Finalize the CD-R/RW.
—
The disc label may not be facing up. Check that the disc label is facing up.
—
The disc may be defective. Try to play back another disc. If the same problem
does not happen, the disc you want to play back is
defective.
—
MP3/WMA disc may not contain
sufficient music tracks to be played back.
Check that your MP3/WMA disc contains at least 5
MP3/WMA music files.
—
The sampling rate of a MP3 or WMA file
may not be compatible with the CD
player.
Check the sampling rate and bit rate of an MP3 or
WMA file are compatible with the CD player.
42
The CD player does
not read CDs.
The disc lens may be dirty. Use a lens cleaner to clean the lens.
42
Remote control
Problem Cause Remedy
See
page
The remote control
does not work nor
function properly.
Wrong distance or angle. The remote control functions within a maximum
range of 6 m (20 ft) and no more than 30 degrees
off-axis from the front panel.
11
Direct sunlight or lighting (from an
inverter type of fluorescent lamp, etc.) is
striking the remote control sensor of this
unit.
Reposition this system.
—
The batteries are weak. Replace all batteries.
11
The system control cable is disconnected
from the system connector jack of the
receiver and/or the CD player.
Connect the receiver and the CD player with the
system control cable firmly.
12