User Manual
Table Of Contents
- Contents
- Introduction
- 1. Trial setup
- 2. Setting up the wireless access point (DHCP server)
- 3. Setting up MLA-200s
- 4. Setting up MRX7-Ds
- 5. Setting up the audio network
- 6. Setting up ML Touch
- 7. Connecting audio devices
- 8. Operation check
- 9. Installing onto an instrument
- 10. Final operation check
- 11. Troubleshooting
18 Music Laboratory System Installation Guide
6. Setting up ML Touch
ML Touch is an iPad application used by instructors to operate the entire system. It can be
downloaded from the App Store.
This describes the setup operations that must be performed before the application can be used. For
details on using ML Touch, refer to the ML Touch User’s Guide.
6-1. Download ML Touch from the App Store.
6-2. Tap the ML Touch icon to start the application.
The initial setup window appears.
Then, if there are no problems, the Home window appears.
If an error appears, check the following.
• Are the MRX7-Ds connected and set up correctly?
• Are the MLA-200s connected correctly and are there no duplicate IP addresses?
If an error appeared, the Home window does not appear. Exit ML Touch, and then start it again.
If the iPad is not connected via Wi-Fi, make settings in iOS.
This completes the setup of ML Touch.