User Manual
Table Of Contents
- Contents
- Introduction
- 1. Trial setup
- 2. Setting up the wireless access point (DHCP server)
- 3. Setting up MLA-200s
- 4. Setting up MRX7-Ds
- 5. Setting up the audio network
- 6. Setting up ML Touch
- 7. Connecting audio devices
- 8. Operation check
- 9. Installing onto an instrument
- 10. Final operation check
- 11. Troubleshooting
Music Laboratory System Installation Guide 25
9. Installing onto an instrument
When placed on a flat surface
When placed on a flat surface of the instrument, be sure to attach the included rubber feet to prevent
slipping.
The installation positions should be about 15 mm inside each edge as shown below. Be sure to attach
all four.
Caution
Position the MLA-200 so that no one will trip and nothing will catch on the cables. If the
MLA-200 falls, it may be damaged or cause injuries.
Less than
15 mm
Less than
15 mm