User Manual
Table Of Contents
- Contents
- Introduction
- 1. Trial setup
- 2. Setting up the wireless access point (DHCP server)
- 3. Setting up MLA-200s
- 4. Setting up MRX7-Ds
- 5. Setting up the audio network
- 6. Setting up ML Touch
- 7. Connecting audio devices
- 8. Operation check
- 9. Installing onto an instrument
- 10. Final operation check
- 11. Troubleshooting
26 Music Laboratory System Installation Guide
10. Final operation check
After installing the MLA-200s onto instruments and setting up the devices, reconnect the cables, and
then perform the final operation check.
The procedure for this operation check is the same as that described in “8. Operation check”
(Page 20), but this time the operation is checked after setting up the system in the classroom.
10-1 . Adjust the volume of the power amplifier (powered speakers) to the
level necessary for use in the actual classroom.
10-2. Check that the MLA-200 for the instructor as well as audio devices,
such as the microphone or CD player, can be operated from ML
Touch.
10-3. Check the communication between ML Touch and the MLA-200s for
students.
This completes the final operation check.