User Manual
6 – MLC-200 Installation Guide
3. Setting up MLA-200s
Each MLA-200 in an audio network is differentiated by the unique ID that is specied.
Specify this ID with the DIP switch.
3-1. With nothing connected, open the DIP switch cover on the rear panel.
One side of the cover remains attached. Disengage the side that does not remain attached, and then slowly
open the cover.
3-2. Set the DIP switch.
The switches of the DIP switch are set to ON when it is down and OFF when it is up.
As a default, all switches are set to OFF (up).
NOTE
Be sure to view the DIP switch in its proper orientation.
Set the DIP switch for each MLA-200 according to the following tables.
Visit Yamaha.io/MLA200Setup or scan the QR code below to utilize our MLA-200 Student Number Helper for
DIP Switch Settings.
Yamaha.io/MLA200Setup
Dip switch cover