Owner`s manual

Quick Guide Creating Your Original Program Set (Master mode)
Creating Your Original Program Set (Master mode)
126
Owner’s Manual
Assigning Control Change numbers to the Knobs/Sliders for each Zone
Here in the KN/CS display of the Master Edit mode, you can set how the Control Knobs and Sliders will affect each Zone.
This lets you specify a separate MIDI Control Change number for each Knob and Slider.
In the example above, the Control Knobs for all Zones have been set to 10 (Pan), and the Sliders have been set to 11
(Expression). In this way, you can control the stereo position of each Zone with the appropriate Knob, and use the Sliders to
adjust the relative volume balance among the Zones.
ASSIGN A
PAN
CUTOFF
SWING
LOW
ASSIGN B
REVERB
RESONANCE
GATE TIME
LOW MID
ASSIGN 1
CHORUS
ATTAC K
VELOCITY
HIGH MID
ASSIGN 2
TEMPO
RELEASE
UNIT MULTIPLY
HIGH
DAW REMOTE PAGE SELECT
PAN SEND
TONE
ARP FX
MASTER
VOLUME
ZONE 1 ZONE 2 ZONE 3 ZONE 4
EQ
ASSIGN
MEF
All indicators are turned off by setting the
[MASTER] → [EDIT] → [COMMON] → [F2] OTHER
→ Knob/Slider parameter to “zone.”
You can determine which Control Change numbers are used
for the Knobs and Sliders for each zone in the [MASTER] →
[EDIT] → Zone selection → [F5] KN/CS display.