Owner`s manual

Voice mode
Performance
mode
Song modeUtility modeFile modeMaster mode
Pattern mode
Mixing Voice
mode
Reference
Voice Edit mode Normal Voice Edit Common Edit
157
Owner’s Manual
FadeOut Determines the amount of time for the LFO effect to fade out (after the Delay time has elapsed). A higher value
results in a slower fade-out.
Settings: 0 – 127
[SF3] PHASE
Phase Determines the value for the particular step selected in the Step parameter below.
Settings: 0, 90, 120, 180, 240, 270
Offset EL1 – EL4 Determines the offset values of the Phase parameter (above) for the respective Elements.
Settings: +0, +90, +120, +180, +240, +270
[SF4] BOX1 – 3
From this display you can select the destination parameter for the LFO (which aspect of the sound the LFO
controls), the Elements to be affected by the LFO, and the LFO Depth. Three pages (boxes) provided for
setting the destination let you assign multiple destinations.
ElemSw (Element Switch) Determines whether or not each Element is to be affected by the LFO. The Element number (1 – 4) is shown
when the LFO is enabled; a dash (–) indicates the LFO is disabled for that Element.
Dest (Destination) Determines the parameters which are to be controlled (modulated) by the LFO Wave.
Settings: amd, pmd, fmd, reso (Resonance), pan, ELFOSpd (Element LFO Speed)
Depth Determines the LFO Wave Depth.
Settings: 0 – 127
DptRatio EL1 – EL4 (Depth
Offset Element 1 – Element 4)
Determines the offset values of the Depth parameter (above) for the respective Elements.
Settings: 0 – 127
[SF5] USER
This menu is available only when the User LFO wave is selected. You can create a custom LFO wave
consisting of up to sixteen steps.
Template You can select a pre-programmed template for the LFO wave. The selected template’s wave graph appears on
the display and you can create the LFO wave by viewing it. Each time pressing the [SF1] random button,
different LFO wave is appears on the display randomly.
Settings:
all0................... Values of all the steps are set to 0.
all64................. Values of all the steps are set to 64.
all127............... Values of all the steps are set to 127.
saw up............. Creates a saw shaped upward wave.
saw down ........ Creates a saw shaped downward wave.
even step......... Values of all even steps are set to 0, and values of all odd steps are set to 127.
odd step .......... Values of all odd steps are set to 0, and values of all even steps are set to 127.
Slope Determines the slope or ramp characteristics of the LFO wave.
Settings: off (no slope), up, down, up&down
Value Determines the value for the particular step selected in the Step parameter below.
Settings: 0 – 127
Step Numerator: Selects the desired step.
Settings: 1 – 16
Denominator: Determines the maximum number of steps.
Settings: 2, 3, 4, 6, 8, 12, 16
FadeOut
Hold
Max
Time
FadeOut
Time
Hold
Max
Low FadeOut value
Faster fade-out
High FadeOut value
Slower fade-out
Time
Phase
0° 90°
120° 240°
180° 270°