Owner`s manual

Voice mode
Performance
mode
Song mode Utility mode File mode Master mode
Pattern mode
Mixing Voice
mode
Reference
Performance Edit mode Part Edit
174
Owner’s Manual
These parameters are for editing the individual Parts that make up a Performance.
Part Edit
[PERFORM] ➞ Performance selection ➞ [EDIT] ➞ Part selection
[F1] VOICE
[SF1] VOICE
You can select a voice for each part.
PartSw (Part Switch) Set each pat to on or off.
Settings: on, off
Bank Determines the Voice Bank (page 40) for each Part.
Number Determines the Voice Program number for each Part.
[SF2] MODE
Mono/Poly Determines the playback method of the Voice for each Part—monophonic (single notes only) or polyphonic
(multiple notes).
Settings: mono, poly
n This parameter is not available for the part to which the Drum Voice is assigned.
ArpSwitch (Arpeggio Switch) Determines whether Arpeggio is on or off for the currently selected Part.
Settings: on, off
[SF3] LIMIT
NoteLimitH (Note Limit High) Determines the lowest and highest notes of the keyboard range for each Part. Each Part will only sound for
notes played within its specified range.
Settings: C -2 – G8
n If you specify the highest note first and the lowest note second, for example “C5 to C4,” then the note range covered will
be “C-2 to C4” and “C5 to G8.”
n You can set the note by pressing the keyboard while holding the [INFORMATION] button.
NoteLimitL (Note Limit Low)
VelLimitH (Velocity Limit High) Determines the minimum and maximum values of the velocity range within which each Part will respond. Each
Part will only sound for notes played within its specified velocity range.
Settings: 1 – 127
n If you specify the maximum value first and the minimum value second, for example “93 to 34,” then the velocity range
covered will be “1 to 34” and “93 to 127.”
VelLimitL (Velocity Limit Low)
[SF4] PORTA (Portamento)
Determines the Portamento parameters for each Part. Portamento is used to create a smooth transition in pitch
from the first note played on the keyboard to the next.
Switch Determines whether Portamento is on or off.
Settings: off, on
Time Determines the pitch transition time. Higher values result in a longer pitch change time.
Settings: 0 –127
Mode Determines the Portamento mode.
Settings: fingr (fingered), full (full time)
fingr (fingered) ......... Portamento is only applied when you play legato (playing the next note before releasing the previous one).
full (full time)............. Portamento is always applied.
n These Portamento parameters above are not available for the part to which the Drum voice is assigned.
[SF5] OTHER
PB (Pitch Bend) Upper,
PB (Pitch Bend) Lower
Determines the amount and direction of Pitch Bend range. Details are same as that in the Common Edit
parameters in Normal Voice mode (page 154).
VelSensDpt
(Velocity Sensitivity Depth)
Determines the degree to which the resulting volume
of the tone generator responds to your playing
strength.
The higher the value, the more the volume changes
in response to your playing strength (as shown at
right).
Settings: 0 – 127
127
0 127
Depth = 127
Depth = 32
Depth = 64
Depth = 0
When Offset (below) is set to 64:
Actual resulting
velocity (affecting
the tone generator)
Velocity with which you play a note