Owner`s manual

Voice mode
Performance
mode
Song mode Utility mode File mode Master mode
Pattern mode
Mixing Voice
mode
Reference
Song Record mode Song Record Standby mode
180
Owner’s Manual
 (Tempo) Determines the Song tempo.
Settings: 001.0 – 300.0
Meas (Measure) Determines the measure from which Song recording will be started.
[F2] VOICE
In this display you can set the voice related parameters for the recording track. The settings here affect the Part for which the receive channel (set in the
Mixing mode) matches the transmit (output) channel of the recording track.
Voice Determines the voice used in the recording track. When the cursor is located here, you can select a voice by
using the Bank, Group, Number buttons and the Category Search function (page 42).
Volume Determines the volume of the recording track.
Settings: 0 – 127
Pan Determines the stereo pan position of the recording track.
Settings: L63 (Left) – C (Center) – R63 (Right)
InsEF
(Insertion Effect Part Switch)
Determines whether the Insertion effects are applied to the recording track or not.
Settings: on, off
 (Tempo) Determines the Song tempo.
Settings: 001.0 –300.0
Meas (Measure) Determines the measure from which Song recording will be started.
[F3] ARP (Arpeggio)
From this display you can set parameters related to the Arpeggio of the recording track.
Bank, Ctgr (Category), Type These three parameters determine the Arpeggio Type. The three-letter prefix number before the Type name
indicates the number within the selected Category.
Settings: Refer to the separate Data List.
VelLimit (Velocity Limit) Determines the lowest and highest velocity which can trigger the Arpeggio playback. The Arpeggio plays
when you play notes at velocities within this range.
Settings: 1 – 127
Hold Determines whether the Arpeggio playback is “held” or not. When this is set to “on,” the Arpeggio cycles
automatically, even if you release your fingers from the keys, and it continues to cycle until the next key is
pressed.
Settings: sync-off, off, on
n About sync-off, see page 154.
PartSw (Part Switch) Determines whether Arpeggio is on or off for the tone generator Part corresponding to the recording track.
Settings: off, on
Meas (Measure) Determines the measure from which Song recording will be started. This parameter is same as the Meas
parameter in the [F1] SETUP display.
[SF1] ARP1 (Arpeggio 1) –
[SF5] ARP5 (Arpeggio 5)
You can register the desired Arpeggio types and Song Scenes to these buttons and call them up any time
during your keyboard performance. Refer to page 89 in the Quick Guide section.
[F4] RECARP (Record Arpeggio)
RecArp (Record Arpeggio) Determines whether the sequence data played by Arpeggio is recorded to the Song track or not. When this is
set to on, the played sequence data is recorded.
Settings: off, on
OutputSwitch Determines whether the sequence data played by Arpeggio during recording is output via MIDI or not. When
this is set to on, the played sequence data by Arpeggio during recording is output via MIDI.
Settings: off, on
TransmitCh (Transmit Channel) Determines the MIDI transmit channel of the Arpeggio playback during recording.
Settings: 1 – 16, KbdCh
[F5] CLICK
Pressing the [F5] button lets you turn the click sound (metronome) on/off for recording.
[F6] ALL TR (All Track)/1TR (1 track)
Pressing the [F6] button lets you switch between Single Track recording and All Track recording.