Owner`s manual
Appendix
Troubleshooting
230
Owner’s Manual
■ Song/Pattern (Phrase) cannot be recorded.
• Is there enough free memory for recording? The total memory capacity determines the number of Songs/Patterns
(phrases) that can be recorded. For example, if the memory contains Songs/Patterns (phrases) that use up a large
amount of memory, the memory may become full even though the available Pattern or Song numbers are not all used.
• In the Pattern Record mode, does the specified track to which the Phrase is assigned have preset data? Recording
cannot be done to a track that contains preset data.
■ Cannot enter the Pattern Job mode/Pattern Mixing mode.
• Check whether this instrument is in the Pattern Chain mode or not. If so, exit from the Pattern Chain mode, then press the
[JOB] button or [MIXING] button.
■ The drum sound is wrong or unexpected when changing the transpose value.
• This is normal. Changing the transpose setting while playing a Drum Voice will produce different sounds for the same keys
played.
■ Data communication between the computer and this instrument does not work properly.
• Check whether the Port setting on the computer is appropriate or not.
• Is the cable setting (MIDI, USB) in the Utility mode appropriate?
■ This instrument does not sound properly even when playing back song data on a computer or a MIDI
instrument connected to this instrument.
• Make sure to set this instrument to the Song mode or Pattern mode. To play back multiple channels simultaneously, Song
mode or Pattern mode must be selected.
■ MIDI bulk data transmission/reception does not work properly.
• Is Bulk data receive protection enabled?
Turn the Receive Bulk parameter to “on.”
• When receiving recorded data with the internal Bulk Dump function, the device number must be set to the same value as
that used when transmitting/recording.
• When transmission does not work properly, is the device number of the MIDI instrument connected to this instrument set
to match the DeviceNo. parameter?
• When using the Voice Editor/Multi Part Editor, have you set a sufficient Dump Interval?
The Dump Interval in the Editor Setup dialog must be set to 20ms or greater. For details refer to the PDF manual included
with the Editor.
■ Data cannot be saved in the USB storage device
• Is the connected USB storage device write protected? (Write-protect should be set to off for saving data.)
• Is the connected USB storage device properly formatted?
■ Cannot enter the Edit mode
• Is the Category Search function turned on?
After exiting from the Category Search function, press the [EDIT] button.
• Is this instrument in the File mode?
After exiting from the File mode, press the [EDIT] button.
[UTILITY] → [F5] MIDI → [SF4] OTHER → MIDI IN/OUT (page 210)
[UTILITY] → [F5] MIDI → [SF2] SWITCH → RcvBulk (page 209)
[UTILITY] → [F5] MIDI → [SF1] CH → DeviceNo. (page 209)
[UTILITY] → [F5] MIDI → [SF1] CH → DeviceNo. (page 209)
[FILE] → [F1] CONFIG → [SF2] FORMAT (page 211)