Owner`s manual

Creating a Song
97
Owner’s Manual
Quick GuideCreating a Song on the MO
Editing a Mixing by using Control sliders (in the Song mode/Pattern mode)
In the Song/Pattern mode, the four Control sliders let you independently adjust the levels of the Parts (Voices), letting
you control the overall balance of the Parts.
n Inadvertent use of the sliders may result in no sound. If this occurs, move the sliders upward.
Creating an Arpeggio
In addition using the preset Arpeggios, you can also create your own original Arpeggio data.
Actually, there is no direct operation for recording Arpeggios. First, you have to record a Phrase to a Song or Pattern
track. Then, use the appropriate Song or Pattern Job function to convert the data to Arpeggio data.
■ Determining how Song/Pattern data is converted to an Arpeggio—Convert Type
MIDI sequence data (of Song/Pattern tracks) can be converted to Arpeggio data in one of three ways, according to
the Convert types below. These types can also be selected independently for each destination track—providing
enormous flexibility and performance control.
[SONG] ➞ Song selection ➞ [MIXING] ➞ [EDIT] ➞ Part selection ➞ [F2] OUTPUT ➞ [SF1] VOL/PAN ➞ Volume
Normal The Arpeggio is played back using only the played note and its octave notes.
Fixed Playing any note(s) will trigger the same MIDI sequence data.
OrgNotes (Original Notes) Basically same as “Fixed” with the exception that the Arpeggio playback notes differ according to the played chord.
TIP
TIP
Track 1
Track 2
Track 3
Track 4
Track 5
Track 6
Track 7
Track 8
Track 9
Track 10
Track 11
Track 12
Track 13
Track 14
Track 15
Track 16
User Arpeggio 256
Song or Pattern
Recording
Recording
Recording
Recording
12
Track 1
Track 2
Track 3
Track 4
User Arpeggio 001
Arpeggio
Convert
[SONG] ➞ [JOB] ➞ [F5] TRACK ➞ 07: Put Track To Arp
You can record MIDI sequence data for
the Arpeggio to any of the tracks. After
recording, select four tracks from all
sixteen and convert them to Arpeggio
data.
Specify the tracks of the source
Song or Pattern. Set unused
tracks to “off.”
Set the root note when the
convert type of any track is
set to “OrgNote.”
Specify the destination Arpeggio number.
Specify the source
Song/Pattern number
and measure range.
Select a convert type by track
(see below).
After setting the parameters as shown below,
press the [ENTER] button to execute Convert.
Convert the MIDI sequence data (recorded to the Song or Pattern) as
Arpeggio data.
Record the MIDI sequence data to be used
as the basis for base of the Arpeggio to a
Song or Pattern.