User Manual

Mobile Music Sequencer Owner’s Manual 7
Importing chord sequences into sections from audio data
Using the procedure described below, you can import chord sequences from
audio data in the Music app on your iPhone or iPad.
1. Tap [CHORD ASSIST] in the Section Editor to open the
screen shown below.
4
6
9
2 13
8
7
Measures
Chord set
5
)
If necessary, tap 9 to make the following settings.
AUDIO VOLUME: Adjust the volume of the audio data.
AUDIO TEMPO: Double or halve the tempo of the audio data.
BEAT SHIFT: Adjust the positions of beats and measures relative to the
audio data.
PROJECT TEMPO: Adjust the tempo of the current project.
2. Tap 1 to display the Music app’s audio list screen.
3. Select audio data as follows.
3-1. Within the list of audio data, tap the one from which you wish to
import chords.
Mobile Music Sequencer will automatically start to play and analyze the data.
NOTE
• If you turn off [REANALYZE] at the bottom-left of the audio list screen, audio data that has
been analyzed already will not be re-analyzed when you tap it again.
• Depending on the type of audio data selected, it may not be possible to analyze chords
accurately.
3-2. Tap [Select] to close the audio list screen.
4. Import the chord sequence from the selected audio data as
follows.
4-1. While playing the audio data using 3, tap 2 to indicate the
approximate location of the chord sequence you wish to import.
Tap ) if you would like the playback position from 2 to be displayed in Area 4.
NOTE
You can also stop playback by tapping 3.
4-2. In Area 7, tap the chord set into which you wish to import the
chord sequence.
When you do so, the measure corresponding to the position set in Step 4-1
and the chord sequence will be displayed in Area 4. In addition, the chord-
set selection range will be displayed as Area 5.
4-3. Adjust the chord-set selection range 5 as appropriate.
To move the selection range: Touch Area 5 and then slide it left or right.
To change the number of measures in the selection range: Touch a
numbered tab in Area 5 and slide it left or right; alternatively, change the
setting in 6.
5. Copy and paste the chord sequence from the chord set into
a section.
To copy the chord sequence: In Area 7, tap the top of the chord set you
wish to copy from, and then tap [Copy] in the menu displayed.
To paste the chord sequence: In Area 8, tap the top of the section you
wish to paste into, and then tap [Paste] in the menu displayed.
NOTE
You can also copy and paste a chord sequence by dragging the chord set and dropping it
onto a section.
6. Tap [EXIT] at the top-right of the screen to return to the
Section Editor.
In the Section Editor, tap [CHORD] to review or edit the imported chord
sequence.
If necessary, tap [SAVE] to save the selected section. Sections saved in this
way can be accessed by setting the Section Select area to User.