User Manual

Editing a Voice
ELC-02/ELCU-M02 Owner’s Manual
137
9
Voice Edit
After you have selected the Voice button, the AWM
Page (first page of the Voice Edit display) will
appear.
If you release the [VOICE EDIT] button before
pressing a Voice button, the Voice Edit function will
not be called up, and the normal Voice Display will
appear.
You can edit an AWM Voice on the AWM Page and
LAYER Page in the Voice Edit display. In the AWM Page,
the tonal balance of the entire Voice can be corrected by
some EQ parameters. In the LAYER Page, you can make
detailed edits to each Element.
AWM Page
1 Element On/Off switches
The [AWM1-4] and [AWM5-8] buttons enable you to
alternate the pages between AWM 1 – 4 and AWM 5 – 8.
The [AWM1] – [AWM8] buttons indicate the Elements
which make up the selected Voice. You can mute any of
the Elements by simply pressing the corresponding
button. Pressing the button again cancels the mute.
2 VOICE/ELEMENT
Indicates the Voice/Element currently being edited. In the
example screen above, Element 1 of Accordion 1 is
assigned to AWM1, Element 2 of Accordion 1 is assigned
to AWM2, and no Voice is assigned to AWM3 and
AWM 4.
You can also call up another Element from another Voice
and replace the currently selected Element with it.
Pressing the VOICE or ELEMENT button in the display
calls up the Voice or Element menu, from which you can
select the desired Voice/ Element (usually Element 1). If
you change the Voice, the Element will automatically
change to the first Element of the Voice (usually Element
1).
3 EQ LOW FREQ./EQ LOW GAIN
Sets the frequency and gain (level) of the low frequency
band. The EQ LOW FREQ. slider sets the desired
frequency band over a range of 32 Hz – 2.0 kHz. The EQ
LOW GAIN slider sets the level for the frequency band
(specified by the EQ LOW FREQ. slider) over a range of
-12 dB – +12 dB.
While holding down…
Press the Voice button.
Editing an AWM Voice
234
1
1