User Manual
Table Of Contents
- System Requirements
- Installation
- Installing Speaker Data
- Uninstalling
- Table of Contents
- 1. Y-S3 General Operation
- 2. Constructing the Room Shape & Audience Area
- 3. Editing Project Properties
- 4. Placing Speakers
- 5. Adjusting Speaker Parameters
- 5-1. Speaker Arrays
- 5-2. Distributed Speakers
- 6. Displaying Calculation Results
- 7. Simulation Results Report
- 8. Exporting Configurations in DME Designer Format
- 9. Other Functions
- 10. General Theory
Yamaha Sound System Simulator Y-S
3
Owner’s Manual V3.1
28
Plane Type
Select from the plane type from the list box (Ceiling, Front Wall, Back Wall, Side Wall 1, Side Wall 2).
Position
Enter the coordinates of the center of the plane. Default settings are x = 0.00, y = a figure determined by room shape,
z = receiving surface + 8.00. Each coordinate can be set in the range of -99.99 m to 99.99 m (-328.0 ft to 328.0 ft).
Plane Size
Enter the size of the plane. Default settings are L = 10 m, W = 10 m. L and W can be set in the range of 1.00 m to 90.00
m (3.3 ft to 295.3 ft).
Plane condition
Select the reflectance of the wall surface (Hard: 100%, Medium: 50%, Transparent: 0%). You can set this parameter to
“Hard” or “Medium” to take the effects of rising acoustic pressure into consideration when placing speakers close to
a plane However, this calculation will not take sound from speakers in installed on this plane into effect.
Angle
Enter the angle of the plane. There are 3 types: Pan (default: depends on plane type), Tilt (default: depends on plane
type) and Rot (default: 0.00). The angle can be set in the range of -180.0 to 180.0.
Coverage (Distributed Speaker Layout Pattern)
Speakers are placed automatically based on the coverage area of the receiving surface. This function is useful when
evaluating the speaker placement necessary to obtain direct distribution of sound.