User Manual
Table Of Contents
16
2-5. Adjusting Speaker Output
On this screen, configure the following items.
・ Ceiling speaker density (quantity) and layout type
・ Surface mount speaker quantity, installation spacing, height and angles (tilt and pan)
・ Subwoofer quantity and installation location
Note: ADVANCED mode only.
2-5-1. Ceiling speakers
Adjusting ceiling speaker output
Density (speaker layout density): Adjust the amount of overlap of the coverage areas, which indicates
the boundaries where the sound pressure is 6 dB lower than at the sound receiving point immediately
below the speaker (on the axis). By default, this is set to Edge-to-Edge.
There are five adjustment levels that you can choose from.
High density
Maximum Overlap
Minimum Overlap
Edge-to-Edge
1.4 x Edge-to-Edge
2.0 x Edge-to-Edge
Low density
When you select a certain density, the software starts calculating and redraws the recalculated
coverage areas.
・ Layout type: By default, speakers are arranged in a square pattern. You can also choose a
hexagonal pattern.
・ Speaker spacing: Shows the spacing between speakers.
Note: Speaker spacing is displayed even if only one speaker has been configured.
Consider this to be an indicator of what the spacing would be if there were a second
speaker.
If the number of speakers could exceed 128, an error message will be displayed.
If this happens, select a layout pattern with a lower density.