User Manual
Table Of Contents
- System Requirements
- Installation
- Installing Speaker Data
- Uninstalling
- Table of Contents
- 1. Y-S3 General Operation
- 2. Constructing the Room Shape & Audience Area
- 3. Editing Project Properties
- 4. Placing Speakers
- 5. Adjusting Speaker Parameters
- 5-1. Speaker Arrays
- 5-2. Distributed Speakers
- 6. Displaying Calculation Results
- 7. Simulation Results Report
- 8. Exporting Configurations in DME Designer Format
- 9. Other Functions
- 10. General Theory
Yamaha Sound System Simulator Y-S
3
Owner’s Manual V3.1
34
Position
Enter the position coordinates of the speaker array. See chapter 4 for details.
Angle
Enter the angle of the speaker. See chapter 4 for details.
Splay Angle
Select the splay angle of the speaker array from the list box. See chapter 4 for details.
Previous/Next Array Geometry
Click or select [Previous Array Geometry (P)] or [Next Array Geometry (N)] from the [Edit (E)] menu to undo/redo
the adjusting of the “Array Geometry” parameters (Position, Angle, Spray Angle) up to 20 times. However depending
on the conditions you have set, you may not be able to return the software to its previous settings.
On Axis
Displays the positional axes and the position in relation to target points.Y-S3 does not display figures for target points
outside the receiving surface.
Target Point
Displays the intersection coordinates (target points) of the axis of the speaker arrays and the receiving surface. Target
points in Aspect View are displayed as black or gray squares on the receiving surfaces. The black square indicates the
target point that is closest to the speaker arrays or speaker. In Array Mode or SPL Mode, you can drag the target points
to move them. A target point can only be moved within the same floor. In Single Mode, the target points of each
speaker are displayed, but you cannot move them. The target point is not displayed when the axis of the array
speakers does not hit the receiving surface. This may be due to the speaker not facing the receiving surface, or being
placed so that its height is the same as that of the receiving surface.
Distance to Array
Displays the distance between the array speaker position and the target point. The target point is not displayed when
the axis of the array speakers does not hit the receiving surface.
Propagation Time
This parameter denotes the propagation time from the array speaker position to the target point. You can refer to
this information when deciding the delay time for each speaker. The target point is not displayed when the axis of
the array speakers does not hit the receiving surface.
Single SP Property
This parameter denotes the properties of the single speakers which construct a speaker array. You can check each