User Manual

15
VXS3SB / VXS3SW / CMA3SB / CMA3SW Owner's Manual
Installing in a ceiling (using the CMA3S)
6
Secure the speaker to the ceiling
6-1
Push the speaker into the ceiling, taking care not to pinch the cables.
NOTICE
When installing the speaker, make sure you do not touch the flaps or subject the
speaker to strong shocks. If the flaps become indented, the sound may become
distorted.
Flaps
6-2
While lifting the speaker up slightly, use a Phillips screwdriver to
turn the screws clockwise and tighten the attachments screws.
The clamp opens when you begin turning the screw. As you
continue to turn the screw, the clamp slides down and pulls the
speaker into the ceiling.
NOTE
If the clamp is difficult to open, turn the screw counter-clockwise one-half revolu-
tion; this will make it easier to open.
Clamp
Attachment
screw
CAUTION
• To prevent stripping the screws, do not overtighten the screws.
• Do not turn any screws other than the attachment screws. This
may cause the speaker to fall or malfunction.
7
Setting the line voltage/impedance and power
7-1
Refer to page 6.
8
Attach the hole cover sheets
8-1
Attach the included hole cover sheets to the screw holes.
9
Attach the grille
9-1
Align the grille to the front of the cabinet and attach the grille.
CAUTION
If the grille is not attached properly, it may fall off after the speaker
is installed.