User Manual

Edit Search Utility Live SetPerformance
Normal Part (AWM2) Drum Part Normal Part (FM-X) Common/Audio
MODX Reference Manual
Normal Part (AWM2) Edit
Common
Part Settings
General
Pitch
Zone Settings
Zone Transmit
Effect
Routing
Ins A
Ins B
EQ
Ins Assign
Arpeggio
Common
Individual
Advanced
Motion Seq
Common
Lane
Mod / Control
Part LFO
Control Assign
Receive SW
Element
Osc / Tune
Pitch EG
Filter
Type
Filter EG
Scale
Amplitude
Level / Pan
Amp EG
Scale
Element LFO
Element EQ
All Element
Osc
Balance
Copy or Exchange
Elements
124
Reference
Time/Vel (AEG Time Velocity Sensitivity)
Segment (AEG Time Velocity Sensitivity Segment)
Determines how the AEG transition time (speed) responds to Velocity, or the strength with which the key is
pressed. Select the “Segment,” and then set its “Time/Vel” parameter.
Settings: Time/Vel: -64 – +63
Positive values: High Velocities result in a fast AEG transition speed while low Velocities result in a slow speed.
Negative values: High Velocities result in a slow AEG transition speed while low Velocities result in a fast speed.
0: The amplitude transition speed does not change, regardless of the Velocity.
Settings: Segment: Attack, Atk+Dcy (Attack+Decay), Decay, Atk+Rls (Attack+Release), All
Attack: Time/Vel parameter affects Attack Time.
Atk+Dcy: Time/Vel Value affects Attack/Decay1 Time.
Decay: Time/Vel parameter affects Decay Time.
Atk+Rls: Time/Vel Value affects Attack/Release Time.
All: Time/Vel affects all AEG Time parameters.
Half Damper (Half Damper Switch)
When the Half Damper Switch is set to on, you can produce a “half-pedal” effect just as on a real acoustic
piano by using the optional FC3 Foot Controller connected to the FOOT SWITCH [SUSTAIN] jack on the
rear panel.
Settings: off, on
Time (Half Damper Time)
Determines how quickly the sound decays to silence after the key is released while holding down the Foot
Controller FC3 with the Half Damper Switch parameter turned on. This is not available when the Half
Damper Switch is set to off.
Settings: 0–127
NOTE For details on AEG, see the Synthesizer Parameter Manual PDF document.