Owners Manual

Table Of Contents
MODX+ Owner’s Manual
46
Recording and Playback
4 Set the following parameters on the Record
Setup display.
4-1
Move the cursor to Time Signature (Meter) (3), and
then set the value. For this example, set this to “4/4.”
4-2 Set Quantize to “240 (8th note)” in Record Quantize
(5). This convenient feature lets you automatically
quantize (or “clean up” the timing of) the notes in real
time, as you record. Quantize aligns the timing of note
events to the nearest beat. Normally, the smallest note
value in the notation (if you're playing from sheet music)
should be set.
5 After completing recording setup, press the
[R] (Play) button to start recording.
Press the [R] (Play) button, then actually start recording
after the count-in.
6 When you’ve finished playing, press the
[J] (Stop) button to stop recording.
If you’ve played any wrong notes, press the [J] (Stop)
button, then try recording again.
Recording with the click
Follow the steps below to use the click during MIDI
recording.
1 Press the [UTILITY] button and touch [Tempo
Settings] (or Touch the [Click Settings] button
where available) on the screen to call up the
Tempo settings display. Set the Click “Mode”
to “Rec.”
NOTE
When “Rec/Play” is set, the click sounds during MIDI recording
and playback. When “Always” is set, the click will always
sound.
Re-recording a specific part of a Song
(Punch In/Out)
Use the Punch In/Out recording method to record over only
a specific portion of the Track. If you set the start point
(Punch In) and end point (Punch Out), and then start
recording from the top of the Song, the actual recording
will be done only between the Punch In and Punch Out
points. In the eight-measure example below, only the third
through the fifth measures are re-recorded.
NOTE
Note that the Punch In/Out method always replaces (destroys)
the original data over the specified area.
To execute Punch In/Punch Out recording in the above
condition, set the following parameters beforehand on the
Record Setup display.
1 “Record Type”: “punch
2 Punch In: 003:01
Playback of the recording Track is turned off from this
point, and your keyboard performance will be
recorded to the Track.
3 Punch Out: 006:01
Recording ends at this point and normal playback of
the recording Track starts.
1234567 8
1234567 8
Before re-recording
Recording start Recording stop
Punch In point
Punch Out point
After re-recording
Newly recorded data
231