Owners Manual

MODX+ Owner’s Manual
48
Recording and Playback
Recording your performance as
audio
Your performances on the MODX+ can be recorded as WAV
format (44.1-kHz, 24-bit, stereo) audio files to a USB flash
drive. The recording level is fixed, and it is possible to record
continuously for up to 74 minutes (assuming that the USB
storage device has sufficient free memory).
NOTICE
The MODX+ should never be turned off during recording,
playback, or while the recorded audio file is being saved.
Turning off the MODX+ at that time may make it impossible
to subsequently access the USB flash drive.
1 Connect a USB flash drive to the [USB TO
DEVICE] terminal of the MODX+.
2 Touch the [Play/Rec] tab in the left of the
Performance Play display.
The recording display appears.
3 Touch the [Audio] tab in the left of the screen.
4 Press the [I] (Record) button to setup the
audio recording.
The Record Setup display appears.
1 Play position
2 Current play position in the entire audio data
3 Available recording time
4 Level meter
5 Trigger level
5 Set the required trigger level (5).
If you set the trigger level to “manual,” recording will
begin whenever you press the [R] (Play) button.
Alternatively, if you set a value between 1 and 127,
recording will begin automatically whenever the
playback volume exceeds that level. The level set here
will be indicated by blue triangles in the level meter (4).
For best results, set this parameter as low as possible to
capture the entire signal, but not so low as to record
unwanted noise.
6 Press the [R] (Play) button.
If you have set the trigger level to “manual,” recording
will begin immediately right after you press the [R] (Play)
button. While the recording, the [I] (Record) button will
light red and the [R] (Play) button will light green. If you
have set a value between 1 and 127 as the trigger level,
the recording will begin automatically whenever the
playback volume exceeds that level.
7 Play the keyboard.
If you set the trigger level to a value between 1 and 127,
recording will begin automatically whenever the
playback volume exceeds that level.
8 When you have finished playing, press the
[J] (Stop) button.
The recorded audio file will be saved on the selected
device.
Playing an audio file
As described below, the MODX+ can play audio files (.wav)
from a USB flash drive, regardless of whether they have
been created by the instrument itself or come from another
source.
1 Connect a USB flash drive to the [USB TO
DEVICE] terminal of the MODX+.
2 Touch the [Play/Rec] tab  [Audio] tab at the
left side of the Performance display.
3 Touch “Audio Name” and then select [Load]
menu at the left side of the screen.
4 Select the source USB flash drive and folder.
5 Select the desired file (.wav) on the USB flash
drive to execute the Load operation.
1 Audio name
2 Audio volume
3 Audio length
6 Press the [R] (Play) button.
The audio file will begin playing.
7 Move the cursor to “Audio Volume” (2), and
then adjust the playback volume by using the
data dial.
8 Press the [J] (Stop) button to stop playback.
NOTE
Keep in mind that you can also play a selected Performance on
the keyboard during audio playback.
2
4
3
5
1
2
3
1