User Manual

Part Parameters
53
1-3-7 Controller Set
The controllers such as knobs on the front panel can be used to change and adjust a variety
of parameters for each Part—both in real time and simultaneously. For example, keyboard
aftertouch can be used to control vibrato and the Modulation Wheel can be used to control
tonal brightness.
The function settings for all controllers are referred to as a Controller Set, and several
Controller Sets can be created for each Part. The controller is referred to as Source, and the
controlled function is referred to as Destination.
Lane Velocity Limit Determines the minimum and maximum Velocity values in which the
Motion Sequence responds.
The Motion Sequence will only be available for notes played between its
specified Velocity Limits. In addition to this, if you first specify the maximum
value then the minimum value which is actually higher than the maximum
value, you can create two Velocity Limits to playback the Motion
Sequence. For example, if you set 93 as the minimum and 34 as the
maximum, then the Velocity range covers both “1 to 34” and “93 to 127,”
with a Velocity “hole” in the middle. For that “hole” between the two Velocity
Limits, the Motion Sequence will not be available.
Lane Unit Multiply Adjusts the Motion Sequencer playback time based on tempo.
By using this parameter, you can create a different Motion Sequencer type
from the original one.
 200%: The playback time will be doubled and the tempo is halved.
 100%: The normal playback time.
 50%: The playback time will be halved and the tempo doubled.
 Common: The value set in the Unit Multiply common to the all Parts
will be applied.
 Arp: The value set in the Arpeggio Unit Multiply for the selected Part
will be applied.
Source Determines which panel controller is to be assigned and used for the
selected Controller Set.
You can assign multiple functions to a controller.
Destination Determines the parameter that is controlled by the Source.
You can select any of the available parameters for each controller, such as
volume, pitch and LFO depth.
Element Switch Determines whether or not the selected controller affects each individual
Element of the current Part.
This parameter is disabled when the Destination is set to a parameter that
is not related to the Part Elements.
For the Normal Part (FM-X), this parameter is changed to “Operator
Switch.”