User Manual

Effects
68
2-3-3 C
Chorus Selects the Chorus type.
Click Density Determines the frequency at which the click sounds.
Click Level Determines the click level.
Clipper Determines the extent to which the Clipper is applied for forcibly reducing
the gain.
Clipper Source Determines the signal to which the Clipper effect is applied for forcibly
reducing the gain.
Color Determines the fixed phase modulation.
The Color parameter may not be effective depending on the values of the
Mode and Stage parameters.
Common Release Determines the amount of time that elapses between the releasing of a
note and the end of the effect.
This is a parameter of Multi Band Comp.
Compression Determines the extent to which the compressor is applied.
Compress Determines the minimum input level at which the compressor effect is
applied.
Comp Attack Determines the amount of time that elapses between the playing of a key
and the start of the compressor effect.
Comp Level Determines the output level of the compressor effect.
Comp Output Level Determines the level of the signal output from the compressor effect.
Comp Ratio Determines the ratio of the compressor.
Comp Release Determines the amount of time that elapses between the release of a note
and the end of the compressor effect.
Comp Sustain Determines the amount of time of the compressor sustain.
Comp SW Turns the compressor on or off.
Comp Threshold Determines the minimum input level at which the compressor effect is
applied.
Control Type This is a parameter of Control Delay.
 Normal: The delay effect is always applied to the sound.
 Scratch: The delay effect is not applied if both the Delay Time and
Delay Time Offset are set to 0.
Crush Type Determines the Bit accuracy.
Curve Determines the velocity curve toward the end of the sound.
Cut Cuts the high frequencies.
Cutoff Frequency Determines the Cutoff Frequency of the Filter for the effect sound.
Cutoff Frequency
Control
Determines the Cutoff Frequency of the Filter.