User Manual

Effects
75
2-3-12 M
Lower Range [VCM Auto Wah, VCM Touch Wah, VCM Pedal Wah] Determines the
minimum value of the wah filter. The Bottom parameter is available only
when the value is less than that of the Top parameter.
[Control Flanger] Determines the minimum value of Flange Control.
[Control Phaser] Determines the minimum value of Phase Control.
[Control Filter] Determines the minimum value of Cutoff Frequency
Control.
LPF Cutoff Frequency Determines the Cutoff Frequency of the Low-Pass Filter.
LPF Resonance Determines the resonance of the low pass filter for the input sound.
Manual Determines a specific value, depending on the selected Effect type.
For VCM Flanger, this parameter determines the offset value of the delay
modulation.
For VCM Phaser mono and VCM Phaser stereo, this parameter
determines the offset value of the phase modulation.
Make Up Gain Determines the output gain of the compressor block.
Master Volume Determines the gain level of the power amplifier.
Mic Output Gate Switch
 Off: Always passes HPF output and “Noise Generator” output.
 On: Passes HPF output and Noise Generator output when there is
audio input data in “Inst.”
Mic Input Level Determines the input level of the microphone sound.
Mic L-R Angle Determines the L/R angle of the microphone.
Mic Position Determines the relative position of the microphone to the speaker.
Mid Determines the characteristic of the mid frequencies.
Mid Attack Determines the amount of time from the moment a key is pressed to the
moment the compressor is applied to the mid frequencies.
Mid Cut Cuts the level of the mid frequencies.
Mid Gain Determines the output gain for the mid frequencies.
Mid Level Determines the output level for the mid frequencies.
Mid Mute Switches the mute status of the mid frequencies.
Mid Ratio Determines the ratio of the compressor for the mid frequencies.
Mid Sweep Determines the frequency range over which the mid frequencies are cut.
Mid Threshold Determines the minimum input level at which the effect is applied for the
mid frequencies.
Mid Width Determines the bandwidth to cut the mid frequencies.
Mix Determines the volume of the effect sound.
Mix Level Determines the level of the effect sound mixed with the dry sound.
Mid1 Subband Gain Lch,
Rch
Determines the gain level of the Mid1 frequencies for the stereo sound (R
and L channels).
Mid2 Subband Gain Lch,
Rch
Determines the gain level of the Mid2 frequencies for the stereo sound (R
and L channels).