User Manual

Effects
77
2-3-14 O
2-3-15 P
Offset Determines the starting pitch in semitones.
Ofs Transition Determines the time that elapses after the Offset value changes.
On/Off Switch For the Isolator, turns the isolator on or off.
For the Stereophonic Optimizer, turns the effect on or off.
OSC Frequency Coarse Determines the frequency at which the sine wave modulates the amplitude
of the input wave.
OSC Frequency Fine Fine-tunes the frequency at which the sine wave modulates the amplitude
of the input wave.
Output Determines the level of the signal output from the effect block.
Output Level Determines the level of the signal output from the effect block.
Output Level 1, 2 Determines the level of the signal output from the first block and second
block, respectively.
Overdrive Determines the degree and character of the distortion effect.
Pan 1, 2 Determines the pan setting for each of the first series and second series.
Pan AEG Min Level This parameter of the Slice effect determines the minimum level of the
Amplitude EG applied to the panned sound.
Pan AEG Type This parameter of the Slice effect determines the type of the Amplitude EG
applied to the panned sound.
Pan Depth Determines the depth of the pan effect.
Pan Direction Determines the direction toward which the stereo pan position of the sound
moves.
Pan Type Determines the pan type.
Panning Determines the spread of the chorus/vibrato.
Pedal Control Determines the Cutoff Frequency of the wah filter.
For best results, assign this parameter to the Foot Controller in the
Controller Set display, then use the Foot Controller to control this
parameter.
Phase Control Determines the depth of phase modulation.
Phase Shift Offset Determines the offset value of the phase modulation.
Phaser SW Determines the Phaser type
Pitch 1, 2 Determines the pitch in semitones for each of the first series and second
series.
Pitch Sweep Sets the pitch to change gradually in each repetition.
Plate Type Determines the sound echo type.
Play Speed Determines the playback speed.
PM Depth Determines the depth of the pitch modulation.
Post-comp HPF Determines the Cutoff Frequency of the High-Pass Filter which follows the
compressor.
Preamp Determines the gain level of the pre-amplifier.