User Manual

MIDI
87
Table 3: RPN Parameter List
3-2-5 Channel Mode message
RPN Parameter
Name
Data Entry (Range) Function
MSB LSB MSB LSB
000 000 Pitch Bend
Sensitivity
0 - 24 - Specifies the amount of pitch bend
produced in response to pitch bend data
in semitone increments.
000 001 Fine Tune 0 - 127 0 - 127 Adjusts the tuning in 100/8192 cent
increments.
The setting values are between -8192
and +8191 based on the formula “MSB x
128 + LSB.”
000 002 Coarse Tune -24 - +24 - Adjusts the tuning in semitone
increments.
127 127 Null - - Voids the RPN and NRPN settings so no
tone generator settings are changed
when subsequent Data Entry messages
are received.
All Sounds Off
(Control #120)
Clears all sounds currently sounding on the specified channel.
However, the status of channel messages such as Hold1 or Sostenuto is
maintained.
Reset All Controllers
(Control #121)
Resets all controllers to their initial values.
However, some controllers are not affected.
All Notes Off
(Control #123)
Clears all notes currently on for the specified channel.
However, if Hold1 or Sostenuto is on, notes will continue sounding until
these are turned off.
Omni Mode Off
(Control #124)
Performs the same operation as when an All Notes Off message is
received.
The receive channel is set to 1.
Omni Mode On
(Control #125)
Performs the same operation as when an All Notes Off message is
received.
Only the receive channel is set to Omni On.
Mono (Control #126) Performs the same operation as when an All Sound Off message is
received.
If the 3
rd
byte parameter (the parameter that determines the mono number)
is 0 - 16, the parts corresponding to those channels are set to Mono.
Poly (Control #127) Performs the same function as when an All Sounds Off message is
received.
Sets the corresponding channel to Poly Mode.