Data List

MONTAGE Data List
151
Effect Parameter List
Category — Lo-Fi
[1] LO-FI
[2] NOISY
[3] DIGITAL TURNTABLE
[4] BIT CRUSHER
Category — TEC
[1] RING MODULATOR
[2] DYNAMIC RING MODULATOR
[3] DYNAMIC FILTER
[4] AUTO SYNTH
No. Parameter Range Value Tbl No.
1 Sampling Frequency Control 44.1 – 344Hz (0 – 127) 12
2 Word Length 1 – 127 (1 – 127)
3 Output Level -6dB – +36dB (0 – 42)
4 Pre-LPF Cutoff Frequency 63Hz – 20.0kHz (10 – 60) 3
5 Filter Type Thru, PowerBass, Radio,
Telephone, Clean, Low
(0 – 5)
6 Pre-LPF Resonance 1.0 – 12.0 (10 – 120)
7 Bit Assign 0 – 6 (0 – 6)
8 Emphasis Off, On (0 – 1)
9—
10 Dry/Wet Balance D63>W – D=W – D<W63 (1 – 127)
11 —
12 —
13 —
14 —
15 Input Mode Mono, Stereo (0 – 1)
16 —
No. Parameter Range Value Tbl No.
1 Mod Depth 0 – 10 (0 – 10)
2 Mod Speed 0 – 127 (0 – 127)
3 Mod Feedback -63 – +63 (1 – 127)
4 Mod Mix Balance 1 – 127 (1 – 127)
5 Drive 0 – 127 (0 – 127)
6 AM Speed 0.00Hz – 39.7Hz (0 – 127) 1
7 AM Depth 0 – 127 (0 – 127)
8 LPF Cutoff Frequency 1.0kHz – 20.0kHz (34 – 60) 3
9 LPF Resonance 1.0 – 12.0 (10 – 120)
10 Dry/Wet Balance D63>W – D=W – D<W63 (1 – 127)
11 EQ Frequency 100Hz – 10.0kHz (14 – 54) 3
12 EQ Gain -12 – +12dB (52 – 76)
13 EQ Width 1.0 – 12.0 (10 – 120)
14 —
15 —
16 —
No. Parameter Range Value Tbl No.
1 Click Density 0 – 5 (0 – 5)
2 Click Level 0 – 127 (0 – 127)
3 Noise Tone 0 – 6 (0 – 6)
4 Noise Mod Speed 0.00Hz – 39.7Hz (0 – 127) 1
5 Noise Mod Depth 0 – 127 (0 – 127)
6 Dry Send to Noise 0 – 127 (0 – 127)
7 Noise LPF Cutoff Frequency 1.0kHz – 20.0kHz (34 – 60) 3
8 Noise LPF Q 1.0 – 12.0 (10 – 120)
9 Noise Level 0 – 127 (0 – 127)
10 —
11 Dry Level 0 – 127 (0 – 127)
12 Dry LPF Cutoff Frequency 1.0kHz – 20.0kHz (34 – 60) 3
13 —
14 —
15 —
16 —
No. Parameter Range Value Tbl No.
1 Sample Rate 0 – 100.00 (0 – 16383)
2 Bit 1 – 16 (1 – 16)
3 Crush Type Soft, Hard (0 – 1)
4 Input Level -19.5dB – +12dB (1 – 127) 47
5 M/S Off, On (0 – 1)
6 Side Sample Rate 0 – 100.00 (0 – 16383)
7 Side Bit 1 – 16 (1 – 16)
8 Sample Rate Link -1.0 – +1.0 (0 – 100)
9 Bit Link -1.0 – +1.0 (0 – 100)
10 Dry/Wet Balance D63>W – D=W – D<W63 (1 – 127)
11 Output Level -19.5dB – +12dB (1 – 127) 47
12 —
13 —
14 —
15 —
16 —
No. Parameter Range Value Tbl No.
1 OSC Frequency Coarse 0.5 – 5kHz (0 – 127) 17
2 OSC Frequency Fine 0 – 127 (0 – 127)
3 LFO Wave Tri, Sine (0 – 1)
4 LFO Depth 0 – 127 (0 – 127)
5 LFO Speed 0.0Hz – 39.70Hz (0 – 127) 1
6 HPF Cutoff Frequency 20Hz – 8.0kHz (0 – 52) 3
7 LPF Cutoff Frequency 1.0kHz – 20.0kHz (34 – 60) 3
8—
9—
10 Dry/Wet Balance D63>W – D=W – D<W63 (1 – 127)
11 —
12 Modulator Input Level -∞dB – 0dB – +24dB (0 – 127) 45
13 – 16: Same as the parameters shaded in gray in CROSS DELAY on page 144.
No. Parameter Range Value Tbl No.
1 Sensitivity 0 – 127 (0 – 127)
2 HPF Cutoff Frequency 20Hz – 8.0kHz (0 – 52) 3
3 LPF Cutoff Frequency 1.0kHz – 20.0kHz (34 – 60) 3
4 Attack Time 0.3ms – 227ms (0 – 127) 15
5 Release Time 2.6ms – 2171ms (0 – 127) 16
6 Release Curve 0 – 127 (0 – 127)
7 Direction Up, Down (0 – 1)
8 Dyna Threshold Level 0 – 127 (0 – 127)
9 Dyna Level Offset 0 – 127 (0 – 127)
10 Dry/Wet Balance D63>W – D=W – D<W63 (1 – 127)
11 —
12 Side Chain Input Level -∞dB – 0dB – +24dB (0 – 127) 45
13 – 16: Same as the parameters shaded in gray in CROSS DELAY on page 144.
No. Parameter Range Value Tbl No.
1 Filter Type LPF (12dB), LPF (18dB), LPF
(24dB), HPF, BPF, BEF
(0 – 5)
2 Sensitivity 0 – 127 (0 – 127)
3 Dyna Level Offset 0 – 127 (0 – 127)
4 Resonance -16 – +111 (0 – 127)
5 Attack Time 0.3ms – 227ms (0 – 127) 15
6 Release Time 2.6ms – 2171ms (0 – 127) 16
7 Release Curve 0 – 127 (0 – 127)
8 Direction up, down (0 – 1)
9 Dyna Threshold Level 0 – 127 (0 – 127)
10 Dry/Wet Balance D63>W – D=W – D<W63 (1 – 127)
11 —
12 Side Chain Input Level -∞dB – 0dB – +24dB (0 – 127) 45
13 – 16: Same as the parameters shaded in gray in CROSS DELAY on page 144.
No. Parameter Range Value Tbl No.
1 Mod Speed 0 – 127 (0 – 127)
2 Mod Wave Type TypeA, TypeB, TypeC,
TypeD
(0 – 3)
3 Mod Depth 0 – 127 (0 – 127)
4 Mod Depth Offset R -63 – +63 (1 – 127)
5 HPF Cutoff Frequency 20Hz – 8.0kHz (0 – 52) 3
6 LPF Cutoff Frequency 1.0kHz – 20.0kHz (34 – 60) 3
7 Delay Time 0.1ms – 370.0ms (1 – 3700)
8 Delay Time Offset R 0 – 884 (0 – 884)
9 Delay Level 0 – 127 (0 – 127)
10 Dry Mix Level 0 – 127 (0 – 127)
11 Feedback Level -63 – +63 (1 – 127)
12 FB Level Offset R -63 – +63 (1 – 127)
13 AM Speed 0.00Hz – 39.7Hz (0 – 127) 1
14 AM Wave Tri, Sine, Saw Up, Saw Down (0 – 3)
15 AM Depth 0 – 127 (0 – 127)
16 AM Inverse R Normal, Inverse (0 – 1)