User Manual

MONTAGE Owner’s Manual
59
Troubleshooting

Are the volume or expression settings too low?
• In case of Normal Part (AWM2) and Drum Part
• In case of Normal Part (FM-X)
 Are the parameter settings such as Element Switch, Note Limit, Velocity Limit, and Velocity Offset appropriate?
• In case of Normal Part (AWM2) and Drum Part
• In case of Normal Part (FM-X)
 Is the Mute switch for each Element/Operator of Part turned on?
 In case of Normal Part (FM-X), is the Carrier Level is set to “0”?
 Is the output parameter of each Part turned off?
No sound from the A/D INPUT jack.
 Is the switch of the microphone turned on?
 Check the microphone type. Make sure to use a dynamic microphone.
 Is the cable between the microphone or audio equipment and this instrument properly connected?
 Is the A/D INPUT [GAIN] knob turned to the minimum?
 Is the A/D INPUT [ON/OFF] button turned on?
 Check whether or not the connection status of the A/D INPUT [L/MONO]/[R] matches the “Mono/Stereo” parameter.
 Check whether or not the “Mic/Line” parameter is set to the appropriate value.
When the output level of the connected equipment (such as a microphone) is low, set this parameter to “Mic.” When the
output level of the connected equipment (such as a synthesizer keyboard, CD player) is high, set this parameter to “Line.”
 Are the volume settings of the A/D Input Part too low?
 Are the effect settings appropriate?
 Is the output setting of the A/D Input Part set appropriately?
 Check whether or not the Vocoder Effect is selected.
When Vocoder is selected as the Insertion Effect for the current Part, the audio signal input from the A/D INPUT [L/MONO]/[R]
jacks may not produce any sound depending on the parameter settings.
[UTILITY]  [Settings]  [Sound]  Tone Generator “Volume”
[EDIT]  PART [COMMON]  [General]  “Volume”
[EDIT]  Part selection  ELEMENT/OPERATOR [COMMON]  [Part Settings]  [General]  “Volume”
[EDIT]  Part selection  ELEMENT/OPERATOR [COMMON]  [Part Settings]  [General]  “Dry Level”
[EDIT]  Part selection  Element/Key selection  [Amplitude]  [Level/Pan]  “Level”
[EDIT]  Part selection  Operator selection  [Level]  “Level”
[EDIT]  Part selection  ELEMENT/OPERATOR [COMMON]  [Part Settings]  [General]
[EDIT]  Part selection  Element/Key selection  [Osc/Tune]
[EDIT]  Part selection  ELEMENT/OPERATOR [COMMON]  [Part Settings]  [General]
[EDIT]  Part selection  Mute Switch of each Element/Operator
[EDIT]  Part selection  Operator selection  [Level]  “Level”
[EDIT]  Part selection  ELEMENT/OPERATOR [COMMON]  [Part Settings]  [General]  “Part Output”
[EDIT]  PART [COMMON]  [Audio In]  [Mixing]  A/D In “Input Mode”
[UTILITY]  [Settings]  [Audio I/O]  “A/D Input”
[EDIT]  PART [COMMON]  [Audio In]  [Mixing]  A/D In “Volume”
[EDIT]  PART [COMMON]  [Audio In]  [Routing]
[UTILITY]  [Settings]  [Audio I/O]  Output
[EDIT]  Part selection  ELEMENT/OPERATOR [COMMON]  [Effect]  [Routing]